Dell Latitude E6440 Dell Owners Manual - Page 22

Installing the Base Corner Caps, Removing the Network Connector

Get Dell Latitude E6440 PDF manuals and user guides View all Dell Latitude E6440 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 22 highlights

Installing the Base Corner Caps 1. Place the left and right base corner caps to align with the screw holes on the computer. 2. Tighten the screws to secure the base corner caps to the computer. 3. Install: a) base cover b) battery 4. Follow the procedures in After Working Inside Your Computer. Removing the Network Connector 1. Follow the procedures in Before Working Inside Your Computer. 2. Remove: a) battery b) base cover c) base corner cap (left) 3. Perform the following steps as shown in the illustration: a) Disconnect the cable from the system board [1]. b) Release cable from the routing channel [2]. c) Remove the screw that secures the network-connector bracket to the computer. 4. Remove the network-connector bracket from the computer. Lift the network connector from the computer. 22

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
Installing the Base Corner Caps
1.
Place the left and right base corner caps to align with the screw holes on the computer.
2.
Tighten the screws to secure the base corner caps to the computer.
3.
Install:
a)
base cover
b)
battery
4.
Follow the procedures in
After Working Inside Your Computer
.
Removing the Network Connector
1.
Follow the procedures in
Before Working Inside Your Computer
.
2.
Remove:
a)
battery
b)
base cover
c)
base corner cap (left)
3.
Perform the following steps as shown in the illustration:
a)
Disconnect the cable from the system board [1].
b)
Release cable from the routing channel [2].
c)
Remove the screw that secures the network-connector bracket to the computer.
4.
Remove the network-connector bracket from the computer. Lift the network connector from the computer.
22