Dell OptiPlex VDI Blaster Edition User Manual - Page 18

Static IP Configuration

Get Dell OptiPlex VDI Blaster Edition PDF manuals and user guides View all Dell OptiPlex VDI Blaster Edition manuals
Add to My Manuals
Save this manual to your list of manuals

Page 18 highlights

Clicking the Change eth0 option will allow you to make changes to your Echo‟s IP configuration. If no changes are necessary, and no further configuration is required, select No Changes and press to continue. Static IP Configuration If DHCP is not available on your LAN, then you must manually set a static IP address for the Echo server. Select the option Change eth0... from the Networking menu. 1 On the next screen named Configuring eth0... select the Static option and press the OK button. 2 Enter the IP address to use as Echo's static IP. Press OK to continue. 3 Enter the subnet mask and then press OK to continue. 4 Enter the gateway IP address and press OK again. 5 Once these three values have been entered, you will be asked to confirm the new static settings. Select Yes to apply the new settings. Otherwise, select No to discard these changes. 6 After selecting Yes, the network interface will restart and you will be presented Echo's Main Menu. 18 | Virtual Appliance Installation & Setup

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
18 |
Virtual Appliance Installation & Setup
Clicking the
Change eth0
option will allow you to make changes to your Echo‟s IP
configuration.
If no changes are necessary, and no further configuration is required,
select
No Changes
and press <Enter> to continue.
Static IP Configuration
If DHCP is not available on your LAN, then you must manually set a static IP
address for the Echo server.
Select the option
Change eth0...
from the
Networking
menu.
1
On the next screen named
Configuring eth0
...
select the
Static
option
and press the
OK
button.
2
Enter the IP address to use as Echo's static IP.
Press
OK
to continue.
3
Enter the subnet mask and then press
OK
to continue.
4
Enter the gateway IP address and press
OK
again.
5
Once these three values have been entered, you will be asked to confirm
the new static settings.
Select
Yes
to apply the new settings.
Otherwise,
select
No
to discard these changes.
6
After selecting
Yes
, the network interface will restart and you will be
presented Echo's
Main Menu
.