Dell P2223HC USB-C Monitor Users Guide - Page 30

Setting up the monitor, Attaching the stand

Get Dell P2223HC PDF manuals and user guides View all Dell P2223HC manuals
Add to My Manuals
Save this manual to your list of manuals

Page 30 highlights

Setting up the monitor Attaching the stand NOTE: The stand is not installed at the factory when shipped. NOTE: The following instructions are applicable only for the stand that was shipped with your monitor. If you are attaching a stand that you purchased from any other source, follow the setup instructions that were included with the stand. To attach the monitor stand: 1. Follow the instructions on the flaps of carton to remove the stand from the cushion that secures it. 2. Remove the stand base and stand riser from the packaging cushion. NOTE: The graphics are used for the purpose of illustration only. The appearance of the package cushion may vary. 3. Insert the stand base blocks fully into the stand slot. 4. Lift the screw handle and turn the screw clockwise. 5. After fully tightening the screw, fold the screw handle flat within the recess. 30 │ Setting up the monitor

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
30± ±
│
±
±
Setting up the monitor
Setting up the monitor
Attaching the stand
NOTE: The stand is not installed at the factory when shipped.
NOTE: The following instructions are applicable only for the stand that
was shipped with your monitor. If you are attaching a stand that you
purchased from any other source, follow the setup instructions that
were included with the stand.
To attach the monitor stand:
1.
Follow the instructions on the flaps of carton to remove the stand from the
cushion that secures it.
2.
Remove the stand base and stand riser from the packaging cushion.
NOTE: The graphics are used for the purpose of illustration only. The
appearance of the package cushion may vary.
3.
Insert the stand base blocks fully into the stand slot.
4.
Lift the screw handle and turn the screw clockwise.
5.
After fully tightening the screw, fold the screw handle flat within the recess.