Dell PowerApp 120 Five-Volt Riser Board Installation
Dell PowerApp 120 Manual
View all Dell PowerApp 120 manuals
Add to My Manuals
Save this manual to your list of manuals |
Dell PowerApp 120 manual content summary:
- Dell PowerApp 120 | Five-Volt
Riser Board Installation - Page 1
Dell™ PowerEdge™ 1550 and PowerApp™ 120 Systems Five-Volt Riser Board Installation www.dell.com | support.dell.com - Dell PowerApp 120 | Five-Volt
Riser Board Installation - Page 2
your computer system. NOTICE: A NOTICE indicates either potential damage to hardware or loss of data and tells you how to avoid the problem. CAUTION: Dell Computer Corporation is strictly forbidden. Trademarks used in this text: Dell, the DELL logo, PowerEdge, and PowerApp are trademarks of Dell - Dell PowerApp 120 | Five-Volt
Riser Board Installation - Page 3
a Peripheral Component Interconnect (PCI) riser board for use with customer-furnished five-volt (5V) PCI cards. Dell does not currently support any 5V PCI cards installed in the Dell™ PowerEdge™ 1550 or PowerApp™ 120 systems. This 5V riser board is furnished for the customer's convenience. These - Dell PowerApp 120 | Five-Volt
Riser Board Installation - Page 4
The 5V riser board contains a single 64-bit, 33-MHz PCI expansion-card connector. NOTE: Connector PCI1 supports a single short 64-bit, 66-MHz expansion card in its fixed socket on the system board. Expansion-Card Installation To install an expansion card on the 5V riser board, perform the following - Dell PowerApp 120 | Five-Volt
Riser Board Installation - Page 5
secure the inner end of the card by closing the plastic latch on the card guide over the top edge of the card. 8. Connect any cables that should be the system into the rack and the top cover, and then reconnect the system and peripherals to their AC power sources and turn them on. support.dell.com - Dell PowerApp 120 | Five-Volt
Riser Board Installation - Page 6
1-4 Five-Volt Riser Board Installation
www.dell.com | support.dell.com
Dell™ PowerEdge™ 1550 and PowerApp™ 120 Systems
Five-Volt Riser Board
Installation