Dell PowerConnect 3324 User's Guide - Page 86

www.dell.com | support.dell.com Connecting Devices After assigning IP addresses to the PowerConnect device, devices are connected to the RJ-45 connectors on the PowerConnect front panel. NOTICE: If auto negotiation is disabled for an RJ-45 port, the auto-MDI/MDI-X pin signal configuration is also disabled. To connect a device to an SFP transceiver port: 1 Use the cabling requirements to select an appropriate SFP transceiver type. 2 Insert the SFP transceiver (sold separately) into the SFP transceiver slot. 3 Use the appropriate network cabling to connect a device to the connectors on the SFP transceiver. NOTICE: When the SFP transceiver acquires a link, the associated integrated 10/100/1000BASE-T port is disabled. To switch off all equipment, the power supply cable is removed from the power supply socket. The power supply socket should be located near the equipment and should be easily accessible. A protection mark B confirms that the equipment is in compliance with the protection usage requirements of standards PN-93/T-42107 and PN-EN 55022: 1996. 86 C o n f i g u r i n g t h e Po w e r C o n n e c t 3 3 2 4 / 3 3 4 8 S w i t c h