Dell PowerConnect 5424 Command Line Interface Guide - Page 457
switchport general pvid
View all Dell PowerConnect 5424 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 457 highlights
User Guidelines • You can use this command to change the egress rule (e.g. from tagged to untagged), without first removing the VLAN from the list. Example The following example shows how to add VLANs 2, 5, and 6 to the allowed list. Console (config)# interface ethernet g8 Console (config-if)# switchport general allowed vlan add 2,5,6 tagged switchport general pvid The switchport general pvid Interface Configuration mode command configures the PVID when the interface is in general mode. Use the no form of this command to configure the default value. Syntax • switchport general pvid vlan-id • no switchport general pvid • vlan-id - PVID (Port VLAN ID). The vlan-id may belong to a non-existent VLAN. Default Configuration VLAN ID=1 Command Mode Interface Configuration (Ethernet, port-channel) mode. User Guidelines • This command has the following consequences: incoming untagged frames are assigned to this VLAN and outgoing traffic in this VLAN on this port is sent untagged (despite the normal situation where traffic sent from a trunk-mode port is all tagged). Example The following example shows how to configure the PVID for g8, when the interface is in general mode. Console (config)# interface ethernet g8 Console (config-if)# switchport general pvid 234 VLAN Commands 457