Dell PowerConnect 8100 Deploying Dell PowerConnect 8100 and Cisco Catalyst Swi - Page 12
Cisco Catalyst CLI, switchport mode trunk
View all Dell PowerConnect 8100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Deploying the Dell PowerConnect 8100 with the Cisco Catalyst Run the commands below to configure Dell PowerConnect 8100 series switch for a tagged VLAN on port 10, egressing to another switch. The native VLAN setting is also shown in the example changing from the default value of 1 to a configured setting of 2. console#configure console(config)#vlan 2,100 console(config-vlan)#exit console(config)#interface te1/0/10 console(config-if-Te1/0/10)#switchport trunk allowed vlan 100 console(config-if-Te1/0/10)#switchport trunk native vlan 2 console(config-if-Te1/0/10)#switchport mode trunk console(config-if-Te1/0/10)#exit Run the commands below to configure the Dell PowerConnect 8100 series switch for a general mode tagged VLAN on port 10, egressing to another switch. The PVID setting is also shown in the example changing from the default value of 1 to a configured setting of 2. The similarities between native VLAN and PVID settings is shown here. console#configure console(config)#vlan 2,100 console(config-vlan)#exit console(config)#interface te1/0/10 console(config-if-Te1/0/10)#switchport general allowed add vlan 100 console(config-if-Te1/0/10)#switchport general pvid vlan 2 console(config-if-Te1/0/10)#switchport mode general console(config-if-Te1/0/10)#exit Cisco Catalyst CLI Run the commands below to configure an access port on a single interface of the Cisco Catalyst 6504. Cat6504E_1(config)#interface te2/7 Cat6504E_1(config-if)#switchport Cat6504E_1(config-if)#switchport access vlan 100 Cat6504E_1(config-if)#switchport mode access Cat6504E_1(config-if)#spanning-tree portfast edge Cat6504E_1(config-if)#no shutdown Cat6504E_1(config-if)#exit 12