Dell PowerConnect B-RX BigIron RX Installation Guide - Page 140
Configuring an automatic Bbot from the interface module's flash memory
View all Dell PowerConnect B-RX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 140 highlights
5 Managing the interface modules The all | parameter specifies that the automatic boot applies to all interface modules in the BigIron RX Series chassis or to an interface module in the specified chassis slot number only. You can specify 1 - 4 for BigIron RX-4, 1 - 8 for BigIron RX-8 or 1 - 16 for BigIron RX-16. Configuring an automatic boot from the management module's flash memory For example, to configure an automatic boot from the primary IronWare image in the management module's flash memory for all interface modules, enter the following command at the global CONFIG level of the CLI: BigIron RX(config)# lp boot system mp primary all Syntax: lp boot system mp primary | secondary all | The primary and secondary keywords specify the primary or secondary IronWare image in the management module's flash memory. The all | parameter specifies that the automatic boot applies to all interface modules in the BigIron RX Series chassis or to an interface module in the specified chassis slot number only. You can specify 1 - 4 for BigIron RX-4, 1 - 8 for BigIron RX-8 or 1 - 16 for BigIron RX-16. Configuring an automatic Bbot from the interface module's flash memory For example, to configure an automatic boot from the primary IronWare image in the interface module's flash memory for all interface modules, enter the following command at the global CONFIG level of the CLI: BigIron RX(config)# lp boot system flash primary all Syntax: lp boot system flash primary | secondary all | The primary and secondary keywords specify the primary or secondary IronWare image in the interface module's flash memory. The all | parameter specifies that the automatic boot applies to all interface modules in the BigIron RX Series chassis or to an interface module in the specified chassis slot number only. You can specify 1 - 4 for BigIron RX-4, 1 - 8 for BigIron RX-8 or 1 - 16 for BigIron RX-16. Configuring an automatic boot from a TFTP server For example, to configure an automatic boot for all interface modules from a TFTP server, enter the following command at the global CONFIG level of the CLI: BigIron RX(config)# lp boot system tftp 123.123.123.123 primary all Syntax: lp boot system tftp all | The parameter specifies the IP address of the TFTP server from which the interface modules will be booted. The parameter specifies the name of the image from which to boot the interface modules. 128 BigIron RX Installation Guide 53-1001811-01