Dell PowerConnect B-RX Multi-Service IronWare Software Release 02.8.00a Releas - Page 5
Supported devices for Multi-Service IronWare Release 02.8.00a, Enhancements, Release 02.8.00a
View all Dell PowerConnect B-RX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Supported devices for Multi-Service IronWare Release 02.8.00a This software release applies to the following Brocade products: • BigIron RX-4 Switch • BigIron RX-8 Switch • BigIron RX-16 Switch • BigIron RX-32 Switch Note: The software release described in this release notes can only be used on the devices specified above. All information required to operate the BigIron RX Series switch is described in the BigIron RX Series Configuration Guide or the Brocade BigIron RX Series Installation Guide. Enhancements The enhancements for the Multi-Service IronWare software are descibed in this section. Release 02.8.00a BigIron RX device does not properly restrict packets sent with a source port of 179. Port 179 is commonly used for Border Gateway Protocol (BGP) communication. These packets are allowed through the system. This has been reported by US-CERT http://www.kb.cert.org/vuls/id/853246 (Defect 000355173). In Release 02.8.00a of the Multi-Service IronWare software, a new CLI command, hw-opt bgp | bfd, was added to disable internal ACLs for BGP and BFD. To deny BGP traffic on the interface 1/15, enter the following commands. BigIron RX(config)# interface ethernet 1/15 BigIron RX(config-if-e10000-1/15)# enable BigIron RX(config-if-e10000-1/15)# hw-opt bgp BigIron RX(config-if-e10000-1/15)# exit Syntax: hw-opt bgp | bfd The bgp parameter disables prioritization of BGP packets. The bfd parameter disables prioritization of BFD packets. Release 02.8.00 The following table lists the enhancements for the release 2.8.00. IronWare Software Release 02.8.00a for Brocade BigIron RX Series Swtches Release Notes v 1.0 Page 5 of 40