Dell PowerConnect J-8216 Release Notes JUNOS version 10.3 - Page 50

J-SRX Series Services Gateways for the Branch Physical Interface Modules Hardware Guide

Page 50 highlights

Junos 10.3 OS Release Notes prepare tinned, solder-plated, or silver-plated connectors or other plated connection surfaces before connecting them, but make sure such surfaces remain clean and free of contaminants. To provide a permanent low-impedance path, tighten all raceway fittings. • An electrical conducting path shall exist between the device chassis and the grounding conductor, or between the chassis and the metal surface of the enclosure or rack in which the device is mounted. Electrical continuity shall be provided by the use of thread-forming-type, unit-mounting screws that remove any paint or nonconductive coatings and establish metal-to-metal contact. Any paint or other nonconductive coatings shall be removed on the surfaces between the mounting hardware and the enclosure or rack. The surfaces shall be cleaned and an antioxidant applied before installation. J-SRX Series Services Gateways for the Branch Physical Interface Modules Hardware Guide • The J-SRX Series Services Gateways for the Branch Physical Interface Modules Hardware Guide erroneously lists the maximum MTU (bytes) for the Serial Mini-PIM as 1504. The correct value for this section is 2000. • The "DOCSIS Mini-Physical Interface Module" chapter in the J-SRX Series Services Gateways for the Branch Physical Interface Modules Hardware Guide erroneously states that the EuroDOCSIS 3.0 and the DOCSIS J (Japan) models of the DOCSIS Mini-PIM are supported. The guide should state that only the DOCSIS 3.0 U.S. model of the DOCSIS Mini-PIM is supported. Related Documentation • New Features in Junos OS Release 10.3 for J-SRX Series Services Gateways on page 4 • Known Limitations in Junos OS Release 10.3 for J-SRX Series Services Gateways on page 24 • Issues in Junos OS Release 10.3 for J-SRX Series Services Gateways on page 29 Hardware Requirements for Junos OS Release 10.3 for J-SRX Series Services Gateways • Transceiver Compatibility for J-SRX Series Devices on page 50 Transceiver Compatibility for J-SRX Series Devices We recommend the use of transceivers compatible with the Junos OS. We cannot guarantee that the interface module will operate correctly if tranceivers are not compatible with the Junos OS. Please contact Dell for the correct transceiver part number for your device. Stream Control Transmission Protocol Overview Stream Control Transmission Protocol (SCTP) is an IP Transport Layer protocol. SCTP is a reliable transport protocol operating on top of a connectionless packet network such as IP and supports data transfer across the network in single IP or multi-IP cases. SCTP provides the following services: 50

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65

prepare tinned, solder-plated, or silver-plated connectors or other plated
connection surfaces before connecting them, but make sure such surfaces remain
clean and free of contaminants. To provide a permanent low-impedance path,
tighten all raceway fittings.
An electrical conducting path shall exist between the device chassis and the
grounding conductor, or between the chassis and the metal surface of the enclosure
or rack in which the device is mounted. Electrical continuity shall be provided by
the use of thread-forming-type, unit-mounting screws that remove any paint or
nonconductive coatings and establish metal-to-metal contact. Any paint or other
nonconductive coatings shall be removed on the surfaces between the mounting
hardware and the enclosure or rack. The surfaces shall be cleaned and an
antioxidant applied before installation.
J-SRX Series Services Gateways for the Branch Physical Interface Modules Hardware
Guide
The
J-SRX Series Services Gateways for the Branch Physical Interface Modules Hardware
Guide
erroneously lists the maximum MTU (bytes) for the Serial Mini-PIM as 1504. The
correct value for this section is 2000.
The “DOCSIS Mini-Physical Interface Module” chapter in the
J-SRX Series Services
Gateways for the Branch Physical Interface Modules Hardware Guide
erroneously states
that the EuroDOCSIS 3.0 and the DOCSIS J (Japan) models of the DOCSIS Mini-PIM
are supported. The guide should state that only the DOCSIS 3.0 U.S. model of the
DOCSIS Mini-PIM is supported.
Related
Documentation
New Features in Junos OS Release 10.3 for J-SRX Series Services Gateways on page 4
Known Limitations in Junos OS Release 10.3 for J-SRX Series Services Gateways on
page 24
Issues in Junos OS Release 10.3 for J-SRX Series Services Gateways on page 29
Hardware Requirements for Junos OS Release 10.3 for J-SRX Series Services Gateways
Transceiver Compatibility for J-SRX Series Devices on page 50
Transceiver Compatibility for J-SRX Series Devices
We recommend the use of transceivers compatible with the Junos OS. We cannot
guarantee that the interface module will operate correctly if tranceivers are not compatible
with the Junos OS. Please contact Dell for the correct transceiver part number for your
device.
Stream Control Transmission Protocol Overview
Stream Control Transmission Protocol (SCTP) is an IP Transport Layer protocol. SCTP
is a reliable transport protocol operating on top of a connectionless packet network such
as IP and supports data transfer across the network in single IP or multi-IP cases. SCTP
provides the following services:
50
Junos 10.3 OS Release Notes