Dell PowerConnect W-7200 Series ArubaOS 6.2 CLI Reference Guide - Page 134

Parameter heartbeatthreshold hop-count link-threshold mesh-ht-ssid-profile max-retries mesh-mcast-opt mesh-survivability metricalgorithm best-link- rssi distributed- tree-rssi Description Range The AP attempts to use the highest transmission rate to establish a mesh link. If a rate is unavailable, the AP goes through the list and uses the next highest rate. 12, 18, 24, 36, 48, 54 Indicates the maximum number of heartbeat 1-255 messages that can be lost between neighboring mesh nodes. Indicates the maximum hop count from the mesh 1-32 portal. Indicates the minimal RSSI value. If the RSSI value is below this threshold, the link may be considered a sub-threshold link. A sub-threshold link is a link whose average RSSI value falls below the configured threshold. If this occurs, the mesh node may try to find a better link on the same channel and cluster (only neighbors on the same channel are considered). The supported threshold is hardware dependent, with a practical range of 10-90. hardware dependent High-throughput SSID Profile for the mesh feature. Maximum number of times a mesh node can re-send 0-15 a packet. Enables or disables scanning of all active stations currently associated to a mesh point to select the lowest transmission rate based on the slowest connected mesh child. When enabled, this setting dynamically adjusts the multicast rate to that of the slowest connected mesh child. Multicast frames are not sent if there are no mesh children. Best practices are to use the default value. Allow mesh points and portals to become active even - if the controller cannot be reached by bridging LAN traffic. This is a beta feature that is disabled by default; it should not be enabled unless you are instructed to do so by Dell technical suppport. Specifies the algorithm used by a mesh node to - select its parent. Best practices are to use the default value distributed-tree-rssi. Selects the parent with the strongest RSSI, - regardless of the number of children a potential parent has. Selects the parent based on link-RSSI and node cost - based on the number of children. This option evenly distributes the mesh points over high quality uplinks. Low quality uplinks are selected as a last resort. Default 12, 18, 24, 36, 48, 54 Mbps 10 8 12 default 4 times enabled distributedtreerssi distributedtreerssi - - 134 | ap mesh-radio-profile Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide