Dell PowerEdge 2950 Information Update - Page 14
Warning! No micro - error codes
View all Dell PowerEdge 2950 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Table 1-1. System Messages (continued) Message Causes Corrective Actions Warning: A fatal error has caused system reset! Please check the system event log! A fatal system error occurred and caused the system to restart. Check the SEL for information that was logged during the error. See the applicable troubleshooting section in See "Troubleshooting Your System" in the Hardware Owner's Manual. for any faulty components specified in the SEL. Warning! No micro Micro code update failed. Update the BIOS firmware. code update loaded See "Getting Help" in the for processor n Hardware Owner's Manual. Warning: The installed memory configuration is not optimal. For more information on valid memory configurations, please see the system documentation on the technical support web site. Invalid memory configuration. The system runs but with reduced functionality. Ensure that the memory modules are installed in a valid configuration. See "General Memory Module Installation Guidelines" in the Hardware Owner's Manual. If the problem persists, see "Troubleshooting System Memory" in the Hardware Owner's Manual. Write fault Write fault on selected drive Faulty USB device, USB medium, optical drive assembly, hard drive, or hard-drive subsystem. Replace the faulty media. Reseat the USB device or USB cable. For hard drive problems, see "Troubleshooting a Hard Drive" in the Hardware Owner's Manual. 14 Information Update