Dell PowerEdge 600SC Microprocessor Upgrade Installation Guide&nbsp - Page 5

Installation and Troubleshooting Guide, Unpack the new microprocessor.

Get Dell PowerEdge 600SC PDF manuals and user guides View all Dell PowerEdge 600SC manuals
Add to My Manuals
Save this manual to your list of manuals

Page 5 highlights

5 Pull the microprocessor socket release lever upward to the fully open position (see Figure 1-2). Figure 1-2. Removing and Replacing the Microprocessor microprocessor microprocessor socket release lever (open position) pin-1 locators NOTICE: Be careful not to bend any of the pins when removing the microprocessor. Bending the pins can permanently damage the microprocessor. 6 Lift the microprocessor out of the socket and leave the release lever in the open position so that the socket is ready for the new microprocessor (see Figure 1-2). 7 Unpack the new microprocessor. If any of the pins on the microprocessor appear bent, see "Getting Help" in your Installation and Troubleshooting Guide for instructions on obtaining technical assistance. 8 Ensure that the microprocessor socket release lever is in the fully open position. 9 Align pin 1 on the microprocessor (see Figure 1-2) with pin 1 on the microprocessor socket. NOTE: No force is needed to install the microprocessor in the socket. When the microprocessor is aligned correctly, it should drop into the socket. Microprocessor Upgrade Installation Guide 1-3

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
Microprocessor Upgrade Installation Guide
1-3
5
Pull the microprocessor socket release lever upward to the fully open position (see
Figure 1-2).
Figure 1-2.
Removing and Replacing the Microprocessor
NOTICE:
Be careful not to bend any of the pins when removing the microprocessor. Bending
the pins can permanently damage the microprocessor.
6
Lift the microprocessor out of the socket and leave the release lever in the open
position so that the socket is ready for the new microprocessor (see Figure 1-2).
7
Unpack the new microprocessor.
If any of the pins on the microprocessor appear bent, see "Getting Help" in your
Installation and Troubleshooting Guide
for instructions on obtaining technical
assistance.
8
Ensure that the microprocessor socket release lever is in the fully open position.
9
Align pin 1 on the microprocessor (see Figure 1-2) with pin 1 on the microprocessor
socket.
NOTE:
No force is needed to install the microprocessor in the socket. When the
microprocessor is aligned correctly, it should drop into the socket.
pin-1 locators
microprocessor
microprocessor socket
release lever
(open position)