Dell PowerEdge 6300 Dell PowerEdge 6300 and 4300 Systems 1 x 2 Backplane Inst - Page 3
Qvwdoolqj²wkh², &²[whqvlrq²&deoh - scsi drive
View all Dell PowerEdge 6300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
,QVWDOOLQJWKH'ULYH&DJH To install the drive cage, perform the following steps: 1. Ensure that the drive cage is correctly assembled: a. Verify that the 1 x 2 backplane is connected to the edge of the auxiliary SCSI backplane via a 100-pin connector. b. Verify that the auxiliary SCSI backplane is inserted into the enclosure on the side of the cage and secured with one screw. c. Verify that the 1 x 2 backplane is secured to the back of the cage with four screws. d. Verify that a drive rail is attached to each side of the drive cage. 2. Insert the drive cage into the empty peripheral drive bay until the clips on the drive rails snap into the sides of the peripheral drive bay (see Figure 1). drive cage drive rail clip )LJXUH,QVWDOOLQJWKH'ULYH&DJH ,QVWDOOLQJWKH,&([WHQVLRQ&DEOH To install the I2C extension cable, perform the following steps: 1. Disconnect the I2C cable from the 20-pin connector on the system board and set it to one side (see Figure 2). Dell PowerEdge 6300 and 4300 Systems 1 x 2 Backplane Installation Information3