Dell PowerEdge 6300 Dell PowerEdge 6300 and 4300 Systems 1 x 2 Backplane Inst - Page 5

,QVWDOOLQJWKH6&6,&DEOH NOTE: The SCSI cable installation described in this document is a typical installation of the SCSI cable used with the 1 x 2 backplane. You can install the SCSI cable differently, depending on redundant arrays of independent disks (RAID) configurations and the existence of SCSI peripheral cards. Refer to your operating system documentation for information on how to set up your SCSI devices. To install the SCSI cable to the 1 x 2 backplane, perform the following steps: 1. In the customer kit, locate the nonterminated 68-pin SCSI cable. (This cable has two connectors at one end and one connector on the other end. See Figure 3.) bottom drive connector top drive connector SCSI controller on system board SCSI cable )LJXUH,QVWDOOLQJWKH6&6,&DEOHWR[%DFNSODQH Dell PowerEdge 6300 and 4300 Systems 1 x 2 Backplane Installation Information5