Dell PowerEdge 6300 Dell PowerEdge 6300 and 4300 Systems 1 x 2 Backplane Inst - Page 4

2. In the customer kit, locate the I 2C extension cable. (This cable has three connectors: a 20-pin connector on one end and in the middle and a 10-pin connector on the other end.) 3. Attach the 10-pin connector on the I 2C extension cable to the 10-pin connector on the 1 x 2 backplane. 4. Attach the 20-pin connector on the I 2C extension cable to the 20-pin connector on the system board. 5. Attach the loose end of the I 2C cable, which was set aside, to the middle connector of the I2C extension cable. 6. Attach a four-wire power cable to the power connector on the 1 x 2 backplane. NOTE: The four-wire power cable is the standard cable found on all systems and provides power to peripherals; for example, for a CD-ROM drive or tape drive. 10-pin connector on 1 x 2 backplane I2C extension cable power connector 20-pin connector on system board hard-disk drive SCSI backplane I2C cable )LJXUH,QVWDOOLQJWKH, &([WHQVLRQ&DEOH 4 Dell PowerEdge 6300 and 4300 Systems 1 x 2 Backplane Installation Information