Dell PowerEdge 6400 Rack Installation Guide - Page 23

Removing the 24-U Rack Doors

Get Dell PowerEdge 6400 PDF manuals and user guides View all Dell PowerEdge 6400 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 23 highlights

05KCEeb1.fm Page 7 Thursday, September 14, 2000 1:37 PM 5HY 2&$7,21 5 0XOWL?9?.&(HEIP hinge pin hinge insert hinge Figure 1-5. Removing the 24-U Rack Doors CAUTION: Store the two doors where they will not injure someone if the doors accidently fall over. If you want to reverse the door so that the handle is on the other side, perform the following steps: 1. With the door open, lift out and fully retract all hinge pins. 2. Remove the hinges and door brackets from the door frame. 3. Replace the hinges and door brackets on the opposite side and switch the position of the handle. 4. Replace the rack door (see the section, "Replacing the Rack Doors", found later in this guide). support.dell.com '(// &21),'(17,$/  3UHOLPLQDU\  Rack Installation Guide 1-7

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
support.dell.com
Rack Installation Guide
1-7
'(//±&21),'(17,$/±²±3UHOLPLQDU\±±±±±³´µ¶´··
±5HY²³´µ¶·µ¸¸¹³),/(³/2&$7,21º
±±5²?³´µ´´¶³´µ··?³´µ¸¸?0XOWL?9¹?´¸.&(HE³ºIP
Figure 1-5.
Removing the 24-U Rack Doors
CAUTION: Store the two doors where they will not injure someone if the
doors accidently fall over.
If you want to reverse the door so that the handle is on the other side, perform the
following steps:
1.
With the door open, lift out and fully retract all hinge pins.
2.
Remove the hinges and door brackets from the door frame.
3.
Replace the hinges and door brackets on the opposite side and switch the posi-
tion of the handle.
4.
Replace the rack door (see the section,
“
Replacing the Rack Doors
”
, found later
in this guide).
hinge insert
hinge
hinge pin
05KCEeb1.fm
Page 7
Thursday, September 14, 2000
1:37 PM