Dell PowerEdge 6400 Rack Installation Guide - Page 33

05KCEeb1.fm Page 17 Thursday, September 14, 2000 1:37 PM 5HY 2&$7,21 5 0XOWL?9?.&(HEIP Reversing the Cable-Management Arm Installation 1. Turn the cable-management arm over (see Figure 1-13). pull pin offset hinge latch pin rail-mounting plate Figure 1-13. Reversing the Cable-Management Arm 2. Remove the pull pins from the offset hinge of the cable-management arm. 3. Remove the rail-mounting plate. NOTE: Make note of the orientation of the rail-mounting plate to the vertical rail. 4. Pull the hinge away from the cable-management arm assembly. 5. Position the offset hinge next to the cable-management arm assembly. 6. Replace the pull pin with the ring facing up. 7. Replace the rail-mounting plate in the same orientation to the opposite vertical rail. 8. Replace the second pull pin with the ring facing up. 9. Perform the steps to install the cable-management arm. The opposite vertical rail and the slotted pocket on the opposite side of the cable tray are used for reverse the installation of the cable-management arm. support.dell.com '(// &21),'(17,$/  3UHOLPLQDU\  Rack Installation Guide 1-17