Dell PowerEdge C6100 Using the Baseboard Management Controller - Page 26
Table 1-25., Firmware Commands NETFUN: 08H, 09H, Commands, NetFn, Request and Response
View all Dell PowerEdge C6100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
www.dell.com | support.dell.com Table 1-25. Firmware Commands (NETFUN: 08H, 09H) Commands Update Firmware NetFn CMD Firmware 01H Request and Response REQUEST Byte 1 Interface Used-Interface the image is transmitted through: 00H: System interface, e.g., KCS 01H: Networking, e.g., TFTP, FTP, or HTTP 02H: USB MSC Byte 2 Update Type: [7]: Force update. 0H: Normal update. An update operation occurs only when the BMC validates the target board, target product, and version number. [6.0]: Reserved Byte 3:14 Install Options: This field is optional. If present, it contains the list of options that control the installation procedure. The number definitions are specific to the vendor. RESPONSE Byte 1 - Completion code Byte 2 - Task ID 26 Using the Baseboard Management Controller