Dell PowerEdge M820 8/4 Gbps FC SAN Module Administrator's Guide - Page 19
Default port mapping, Remapping ports, FC SAN Module default F_Port-to-N_Port mapping
View all Dell PowerEdge M820 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Port mapping 2 Default port mapping Table 3 shows the default port mapping. By default, Failover and Failback policy are enabled on all external ports (N_Ports). TABLE 3 Total Ports FC SAN Module default F_Port-to-N_Port mapping Server Ports (F_Ports) External Ports (N_Ports) Default F_ to N_Port Mapping 24 1-16 0, 17-23 1, 2 mapped to 17 3, 4 mapped to 18 5, 6 mapped to 19 7, 8 mapped to 20 9, 10 mapped to 21 11, 12 mapped to 22 13, 14 mapped to 23 15, 16 mapped to 0 The FC SAN Module ships with 12 active ports and two installed SFP+ optical transceivers. A port upgrade license is available to activate 12 additional ports and includes two additional SFP+ transceivers. Additional single SFP+ transceivers are also available for maximum bandwidth and redundancy. By default, port licensing on the FC SAN Module is dynamic, so port licenses are flexibly assigned from the pool of available licenses. Ports 17 and 18 are licensed at the factory (and align with the two included SFP+ transceivers). The remaining ten licenses are assigned to active ports as required, making port licensing more flexible. If no additional SFP+ transceivers are used to enable additional external ports on the FC SAN Module and your M1000e blade chassis contains more than four blade servers, you should make modifications to the default port mapping to ensure connectivity for all servers to the SAN. Remapping ports You extern can modify the default port mapping by adding internal ports (F_Ports) to an external port (N_Port). Doing so, routes that traffic to and from the fabric through the specified external port. You can assign an internal port to only one primary external port at a time. If the internal is already assigned to an external port, you must remove it from the external port before you can add it to a different port. Use the following steps to add an internal port (F_Port) to an external port (N_Port). 1. Connect to the FC SAN Module and log in using an account assigned to the admin role. 2. Enter the command with the --mapadd n_portnumber "f_port1;f_port2;... "operand to add the list of internal to the external port. The f_portlist can contain multiple internal ports (F_Ports) numbers separated by semicolons, for example "17;18". switch:admin> ag --mapadd 13 "6;7" F-Port to N-Port mapping has been updated successfully Dell 8/4Gbps FC SAN Module Administrator's Guide 5 53-1001345-01