Dell PowerEdge MX840c EMC PowerEdge MX7000 Enclosure Installation and Service - Page 19
Initial system setup and configuration, Setting up your enclosure, Management module configuration
View all Dell PowerEdge MX840c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
4 Initial system setup and configuration Setting up your enclosure Complete the following steps to set up your enclosure: Steps 1. Unpack the enclosure. 2. Install the enclosure into the rack. For more information, see the Rail Installation Guide at www.dell.com/poweredgemanuals. 3. Connect the peripherals to the enclosure. 4. Connect the enclosure to its electrical outlet. 5. Power on the enclosure by pressing the power button. NOTE: You can configure the static or DHCP IP address using the touch panel on the chassis. 6. Power on the attached peripherals. For more information about setting up your enclosure, see the Getting Started Guide that shipped with your enclosure. Management module configuration Using the management module (MM), you can manage SAS storage subsystem, drive assignments, and monitor the health status for the associated SAS devices. You can manage SAS fabric by using the OpenManage Enterprise-Modular user interface to view inventory, storage event logs and manage drive or enclosure assignments. For more information about managing the SAS fabric using OpenManage Enterprise-Modular, see OpenManage Enterprise-Modular User's Guide available at www.dell.com/openmanagemanuals > Chassis Management Controllers. Options to set up the management module IP address Configure the initial network settings on your network infrastructure to enable the communication to and from the management module. NOTE: For static IP configuration, you must request for it at the time of purchase. Use the OpenManage Essentials Quick Deploy feature to assign a static or DHCP IP address. Interfaces Document/Section Dell Deployment Toolkit Dell Lifecycle Controller OpenManage Enterprise Modular Server LCD panel Management module and Quick Sync 2 (optional) See Dell Deployment Toolkit User's Guide at www.dell.com/openmanagemanuals > OpenManage Deployment Toolkit See Dell Lifecycle Controller User's Guide at www.dell.com/idracmanuals > Lifecycle Controller See Dell OpenManage Enterprise-Modular User's Guide at www.dell.com/openmanagemanuals > Chassis Management Controllers See the LCD touch-panel section. See Dell Integrated Dell Remote Access Controller User's Guide at www.dell.com/idracmanuals NOTE: To access the management module, ensure that all the management modules are connected to the network. You can also access the management module through the shared LOM mode, if you have opted for a system that has the shared LOM mode enabled. Initial system setup and configuration 19