Dell PowerEdge MX840c EMC PowerEdge MX7000 Enclosure Installation and Service - Page 42
Removing a MX7000 blank from Fabric C slot, Installing a MX7000 blank in Fabric C slot
![]() |
View all Dell PowerEdge MX840c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Next steps 1. Connect the cables to the module. Removing a MX7000 blank from Fabric C slot Steps 1. Press the release button to release the blank. 2. Pull the blank out of the enclosure. NOTE: To maintain proper airflow, ensure that the blanks are installed if the MX7000 IOMs is not installed. Figure 32. Removing a blank from Fabric C slot Next steps 1. Install the module in the Fabric C slot or a blank. Installing a MX7000 blank in Fabric C slot Prerequisites 1. Follow the safety guidelines listed in Safety instructions. 2. Remove the module from Fabric C slot. Steps 1. Align and insert the blank in the empty slot. 2. Push the blank until it locks into place. 42 Installing and removing system components
![](/manual_guide/products/dell-poweredge-mx5016s-emc-poweredge-mx7000-enclosure-installation-service-manual-fae4c79/42.png)
Next steps
1.
Connect the cables to the module.
Removing a MX7000 blank from Fabric C slot
Steps
1.
Press the release button to release the blank.
2.
Pull the blank out of the enclosure.
NOTE:
To maintain proper airflow, ensure that the blanks are installed if the MX7000 IOMs is not installed.
Figure 32. Removing a blank from Fabric C slot
Next steps
1.
Install the module in the Fabric C slot
or
a blank
.
Installing a MX7000 blank in Fabric C slot
Prerequisites
1.
Follow the safety guidelines listed in
Safety instructions
.
2.
Remove the module from Fabric C slot
.
Steps
1.
Align and insert the blank in the empty slot.
2.
Push the blank until it locks into place.
42
Installing and removing system components