Dell PowerEdge R210 Hardware Owner's Manual - Page 20
NVRAM_CLR jumper, BIOS Update - boot failed
View all Dell PowerEdge R210 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Message Causes Corrective Actions Alert! System fatal error during previous boot. An error caused the system to reboot. Check other system messages for additional information for possible causes. BIOS MANUFACTURING MODE detected. MANUFACTURING MODE will be cleared before the next boot. System reboot required for normal operation. System is in manufacturing Reboot to take the system mode. out of manufacturing mode. BIOS Update Remote BIOS update Attempt Failed! attempt failed. Retry the BIOS update. If problem persists, see "Getting Help" on page 133. Caution! NVRAM_CLR jumper is installed on system board. Please run SETUP. NVRAM_CLR jumper is installed in the clear setting. CMOS has been cleared. Move the NVRAM_CLR jumper to the default position (pins 3 and 5). See Figure 6-1 for jumper location. Restart the system and re-enter the BIOS settings. See "Using the System Setup Program and UEFI Boot Manager" on page 37. CPU set to minimum frequency. The processor speed may be If not an intentional setting, intentionally set lower for check any other system power conservation. messages for possible causes. 22 About Your System