Dell PowerEdge R940 EMC Technical Specifications - Page 13

Expanded operating temperature restrictions, Thermal restrictions

Page 13 highlights

Table 17. Expanded operating temperature specifications (continued) Expanded operating temperature Specifications NOTE: Outside the standard operating temperature (10°C to 35°C), the system can operate continuously in temperatures as low as 5°C and as high as 40°C. For temperatures between 35°C to 40°C, de-rate maximum allowable temperature by 1°C per 175 m above 950 m (1°F per 319 ft). ≤ 1% of annual operating hours -5°C to 45°C at 5% to 90% RH with 29°C dew point. NOTE: Outside the standard operating temperature (10°C to 35°C), the system can operate down to -5°C or up to 45°C for a maximum of 1% of its annual operating hours. For temperatures between 40°C and 45°C, de-rate maximum allowable temperature by 1°C per 125 m above 950 m (1°F per 228 ft). NOTE: When operating in the expanded temperature range, system performance may be impacted. NOTE: When operating in the expanded temperature range, ambient temperature warnings may be reported in the System Event Log. Expanded operating temperature restrictions • Do not perform a cold startup below 5°C. • The operating temperature specified is for a maximum altitude of 3050 m (10,000 ft). • 150 W/8 core, 165 W/12 core and higher wattage processor [Thermal Design Power (TDP)>165 W] are not supported. • Redundant power supply unit is required. • Non-Dell qualified peripheral cards and/or peripheral cards greater than 25 W are not supported. • NVMe drives are not supported. • NVDIMMs are not supported. • DCPMMs are not supported. • Tape backup unit is not supported. Thermal restrictions Following table lists the configuration required for efficient cooling. Table 18. Thermal restriction for efficient cooling Configuration Number of processor s Heatsink Eight 2.5 inch 2 hard drive system Two heat sinks for CPU < 165W Two heat sinks for CPU ≥ 165 W Processor blank Not required DIMM blanks Fresh air 12 Yes No Fan eight standard fans 4 Twenty four 2 2.5 inch hard drive system 4 Four standard heat sinks for Not required CPU < 165 W Four heat sinks CPU ≥ 165 W Two standard heat sinks for Not required CPU < 165W Two heat sinks for CPU ≥ 165 W Four standard heat sinks for Not required CPU < 165 W 24 Yes No 12 Yes No 24 Yes eight standard fans eight standard fans eight standard fans PowerEdge R940 technical specifications 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17

Table 17. Expanded operating temperature specifications (continued)
Expanded operating temperature
Specifications
NOTE:
Outside the standard operating temperature (10°C to
35°C), the system can operate continuously in temperatures as
low as 5°C and as high as 40°C.
For temperatures between 35°C to 40°C, de-rate maximum allowable
temperature by 1°C per 175 m above 950 m (1°F per 319 ft).
≤ 1% of annual operating hours
–5°C to 45°C at 5% to 90% RH with 29°C dew point.
NOTE:
Outside the standard operating temperature (10°C to
35°C), the system can operate down to –5°C or up to 45°C for a
maximum of 1% of its annual operating hours.
For temperatures between 40°C and 45°C, de-rate maximum allowable
temperature by 1°C per 125 m above 950 m (1°F per 228 ft).
NOTE:
When operating in the expanded temperature range, system performance may be impacted.
NOTE:
When operating in the expanded temperature range, ambient temperature warnings may be reported in the
System Event Log.
Expanded operating temperature restrictions
Do not perform a cold startup below 5°C.
The operating temperature specified is for a maximum altitude of 3050 m (10,000 ft).
150 W/8 core, 165 W/12 core and higher wattage processor [Thermal Design Power (TDP)>165 W] are not supported.
Redundant power supply unit is required.
Non-Dell qualified peripheral cards and/or peripheral cards greater than 25 W are not supported.
NVMe drives are not supported.
NVDIMMs are not supported.
DCPMMs are not supported.
Tape backup unit is not supported.
Thermal restrictions
Following table lists the configuration required for efficient cooling.
Table 18. Thermal restriction for efficient cooling
Configuration
Number
of
processor
s
Heatsink
Processor blank
DIMM
blanks
Fresh air
Fan
Eight 2.5 inch
hard drive
system
2
Two heat sinks for CPU <
165W
Not required
12
Yes
eight standard
fans
Two heat sinks for CPU ≥
165 W
No
4
Four standard heat sinks for
CPU < 165 W
Not required
24
Yes
eight standard
fans
Four heat sinks CPU ≥ 165 W
No
Twenty four
2.5 inch hard
drive system
2
Two standard heat sinks for
CPU < 165W
Not required
12
Yes
eight standard
fans
Two heat sinks for CPU ≥
165 W
No
4
Four standard heat sinks for
CPU < 165 W
Not required
24
Yes
eight standard
fans
PowerEdge R940 technical specifications
13