Dell PowerSwitch S4112F-ON EMC SmartFabric OS10 User Guide Release 10.5.1 - Page 1241

○ DST_IPv6-Destination address ○ SRC_IPv6-Source address ○ IP_TYPE-IP Type; for example, IPv4 or IPv6 ○ IP_PROTOCOL-TCP, UDP, and so on ○ L4_DST_PORT-Destination port ● MAC qualifiers: ○ OUT_PORT-Egress CPU port ○ SRC_MAC-Source MAC address ○ DST_MAC-Destination MAC address ○ ETHER_TYPE-Ethertype ○ OUTER_VLAN_ID-VLAN ID ○ IP_TYPE-IP type ○ OUTER_VLAN_PRI-DOT1P value IP fragment handling OS10 supports a configurable option to explicitly deny IP-fragmented packets, particularly for the second and subsequent packets. This option extends the existing ACL command syntax with the fragments keyword for all L3 rules: ● Second and subsequent fragments are allowed because you cannot apply a L3 rule to these fragments. If the packet is denied eventually, the first fragment must be denied and the packet as a whole cannot be reassembled. ● The system applies implicit permit for the second and subsequent fragment before the implicit deny. ● If you configure an explicit deny, the second and subsequent fragments do not hit the implicit permit rule for fragments. IP fragments ACL When a packet exceeds the maximum packet size, the packet is fragmented into a number of smaller packets that contain portions of the contents of the original packet. This packet flow begins with an initial packet that contains all of the L3 and Layer 4 (L4) header information contained in the original packet, and is followed by a number of packets that contain only the L3 header information. This packet flow contains all of the information from the original packet distributed through packets that are small enough to avoid the maximum packet size limit. This provides a particular problem for ACL processing. If the ACL filters based on L4 information, the non-initial packets within the fragmented packet flow will not match the L4 information, even if the original packet would have matched the filter. Because of this filtering, packets are not processed by the ACL. The examples show denying second and subsequent fragments, and permitting all packets on an interface. These ACLs deny all second and subsequent fragments with destination IP 10.1.1.1, but permit the first fragment and non-fragmented packets with destination IP 10.1.1.1. The second example shows ACLs which permits all packets - both fragmented and non-fragmented - with destination IP 10.1.1.1. Deny second and subsequent fragments OS10(config)# ip access-list ABC OS10(conf-ipv4-acl)# deny ip any 10.1.1.1/32 fragments OS10(conf-ipv4-acl)# permit ip any 10.1.1.1/32 Permit all packets on interface OS10(config)# ip access-list ABC OS10(conf-ipv4-acl)# permit ip any 10.1.1.1/32 OS10(conf-ipv4-acl)# deny ip any 10.1.1.1/32 fragments L3 ACL rules Use ACL commands for L3 packet filtering. TCP packets from host 10.1.1.1 with the TCP destination port equal to 24 are permitted, and all others are denied. Access Control Lists 1241