Dell PowerSwitch S5212F-ON Open Networking Hardware Diagnostic Guide April 201 - Page 12
Installation ONIE from BIOS
View all Dell PowerSwitch S5212F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
6 Start TFTP waterfall-from the DHCPv4 option 66. ONIE ifconfig eth0 command examples If none of the ONIE Service Discovery methods are successful, you can disable this using the onie-discovery-stop command. You can install an operating system manually from HTTP, USB, FTP, or TFTP using the onie-nos-install command. NOTE: If you have a recovery USB plugged into your system, you must remove it using the onie-nos-install command. The ONIE Install environment uses DHCP to assign an IP address to the management interface, eth0. If that fails, it uses the link-local IPv4 address 169.254.209.190/16. To display the IP address, use the ifconfig eth0 command, as shown: ONIE:/ # ifconfig eth0 eth0 Link encap:Ethernet HWaddr 90:B1:1C:F4:9C:76 inet addr:x.x.x.x Bcast:x.x.x.x Mask:x.x.x.x inet6 addr: fe80::92b1:1cff:fef4:9c76/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:18 errors:0 dropped:0 overruns:0 frame:0 TX packets:24 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:1152 (1.1 KiB) TX bytes:6864 (6.7 KiB) Interrupt:21 Memory:ff300000-ff320000 To assign an IP address to the management interface, eth0, and verify network connectivity, use the ifconfig eth0 command, as shown: ONIE:/ # ifconfig eth0 x.x.x.x netmask x.x.x.x UP Then set speed on management interface as below ONIE:/ # ethtool -s eth0 speed 100 duplex full Verify the network connection with ping. ONIE:/ # ping x.x.x.x PING x.x.x.x (x.x.x.x): 56 data bytes 64 bytes from x.x.x.x: seq=0 ttl=62 time=1.357 ms 64 bytes from x.x.x.x: seq=1 ttl=62 time=0.577 ms ^C Installation ONIE from BIOS Install ONIE from the BIOS using the media (usb) boot-the ONIE installer USB. Pre-requisites The BIOS running on your system must meet the following requirements: • Allows a change to the boot order so the system can boot from media (USB). • Allows a baud-rate change. This feature is optional; you do not need it if your BIOS is running at 115200 baud rate. The default baud rate for ONIE is 115200. CAUTION: • These procedures are for x86-based targets only, particularly targets using Rangeley or Centerton CPU-based boards. • Check the console (UART-0/1) used on the target. • The log messages included in this guide are subject to change. NOTE: The following procedure is generic and does not list a particular target. Therefore, the ONIE images are specified using the _ notation. For example, the ONIE media (usb) iso image is onie-recovery-x86_64dell__-r0.iso. 12 ONIE installation instructions