Dell PowerVault DL2100 Hardware Owner's Manual - Page 155
Replace the cooling shroud. See Installing the Cooling Shroud.
![]() |
View all Dell PowerVault DL2100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 155 highlights
If diagnostics indicates a fault, follow the corrective actions provided by the diagnostic program. 2 If the system is not operational, turn off the system and attached peripherals, and unplug the system from the power source. Wait at least 10 seconds and then reconnect the system to power. 3 Turn on the system and attached peripherals and note the messages on the screen or LCD panel. Go to step 14 if an error message appears indicating a fault with a specific memory module. 4 Enter the System Setup program and check the system memory setting. See "Memory Settings Screen." Make any changes to the memory settings, if needed. If the memory settings match the installed memory but a problem is still indicated, go to step 14. 5 Turn off the system and attached peripherals, and disconnect the system from the electrical outlet. 6 Open the system. See "Opening the System." 7 Remove the cooling shroud. See "Removing the Cooling Shroud." 8 Check the memory channels and ensure that they are populated correctly. See "General Memory Module Installation Guidelines." 9 Reseat the memory modules in their sockets. See "Installing Memory Modules." 10 Replace the cooling shroud. See "Installing the Cooling Shroud." 11 Close the system. See "Closing the System." 12 Reconnect the system to its electrical outlet, and turn on the system and attached peripherals. 13 Enter the System Setup program and check the system memory setting. See "Memory Settings Screen." If the problem is not resolved, proceed with the next step. 14 Turn off the system and attached peripherals, and disconnect the system from the power source. 15 Open the system. See "Opening the System." Troubleshooting Your System 155
![](/manual_guide/products/dell-powervault-dl2100-hardware-owners-manual-397becf/155.png)