Dell PowerVault DR6000 Getting Started Guide - Page 8

Environmental, Maximum Shock, Maximum Altitude, Operating Altitude De-rating

Get Dell PowerVault DR6000 PDF manuals and user guides View all Dell PowerVault DR6000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 8 highlights

Environmental Storage 1.87 Grms at 10 Hz to 500 Hz for 15 min (all six sides tested). Maximum Shock Operating One shock pulse in the positive z axis of 31 G for 2.6 ms in all operational orientations. Storage Six consecutively executed shock pulses in the positive and negative x, y, and z axes (one pulse on each side of the system) of 71 G for up to 2 ms. Maximum Altitude Operating 3048 m (10,000 ft) Storage 12,000 m (39,370 ft) Operating Altitude De-rating Up to 35 °C (95 °F) Maximum temperature is reduced by 1 °C/300 m (1 °F/547 ft) above 950 m (3,117 ft). 35 °C to 40 °C (95 °F to 104 °F) Maximum temperature is reduced by 1 °C/175 m (1 °F/319 ft) above 950 m (3,117 ft). 40 °C to 45 °C (104 °F to 113 °F) Maximum temperature is reduced by 1 °C/125 m (1 °F/228 ft) above 950 m (3,117 ft). Particulate Contamination NOTE: This section defines the limits to help avoid IT equipment damage and/or failure from particulates and gaseous contamination. If it is determined that levels of particulates or gaseous pollution are beyond the limits specified below and are the reason for the damage and/or failures to your equipment, it may be necessary for you to re-mediate the environmental conditions that are causing the damage and/or failures. Re-mediation of environmental conditions is the responsibility of the customer. Air Filtration Data center air filtration as defined by ISO Class 8 NOTE: Applies to data center per ISO 14644-1 with a 95% upper confidence limit environments only. Air filtration NOTE: Air entering the data center must have requirements do not apply to IT MERV11 or MERV13 filtration. equipment designed to be used outside a data center, in environments such as an office or factory floor. Conductive Dust NOTE: Applies to data center and nondata center environments. Air must be free of conductive dust, zinc whiskers, or other conductive particles. Corrosive Dust NOTE: Applies to data center and nondata center environments. • Air must be free of corrosive dust. • Residual dust present in the air must have a deliquescent point less than 60% relative humidity. 8

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
Environmental
Storage
1.87 G
rms
at 10 Hz to 500 Hz for 15 min (all six sides
tested).
Maximum Shock
Operating
One shock pulse in the positive z axis of 31 G for 2.6
ms in all operational orientations.
Storage
Six consecutively executed shock pulses in the
positive and negative x, y, and z axes (one pulse on
each side of the system) of 71 G for up to 2 ms.
Maximum Altitude
Operating
3048 m (10,000 ft)
Storage
12,000 m (39,370 ft)
Operating Altitude De-rating
Up to 35 °C (95 °F)
Maximum temperature is reduced by 1 °C/300 m (1
°F/547 ft) above 950 m (3,117 ft).
35 °C to 40 °C (95 °F to 104 °F)
Maximum temperature is reduced by 1 °C/175 m (1
°F/319 ft) above 950 m (3,117 ft).
40 °C to 45 °C (104 °F to 113 °F)
Maximum temperature is reduced by 1 °C/125 m (1
°F/228 ft) above 950 m (3,117 ft).
Particulate Contamination
NOTE:
This section defines the limits to help avoid IT equipment damage and/or failure from
particulates and gaseous contamination. If it is determined that levels of particulates or gaseous
pollution are beyond the limits specified below and are the reason for the damage and/or failures
to your equipment, it may be necessary for you to re-mediate the environmental conditions that
are causing the damage and/or failures. Re-mediation of environmental conditions is the
responsibility of the customer.
Air Filtration
NOTE:
Applies to data center
environments only. Air filtration
requirements do not apply to IT
equipment designed to be used outside a
data center, in environments such as an
office or factory floor.
Data center air filtration as defined by ISO Class 8
per ISO 14644-1 with a 95% upper confidence limit
NOTE:
Air entering the data center must have
MERV11 or MERV13 filtration.
Conductive Dust
NOTE:
Applies to data center and non-
data center environments.
Air must be free of conductive dust, zinc whiskers,
or other conductive particles.
Corrosive Dust
NOTE:
Applies to data center and non-
data center environments.
•
Air must be free of corrosive dust.
•
Residual dust present in the air must have a
deliquescent point less than 60% relative
humidity.
8