Dell PowerVault DX6112 Dell DR Series System Release Notes For Release 2.0.1.0 - Page 13

Error Issue Code Description Workaround/Solution 14949 • --tcp_dump- Collect tcp dump report. [--logs] [--cores] [--tcp_dump] [--all] The auto_diags option is hidden since this is a very special use case. CLI expansion license was showing up as "In Use: No" even though the expansion license was installed. Corrected the CLI command system show --license -verbose to -- [root@swsys-221 ~]# system --show -- display the license in the correct state. license --verbose Feature ID: 3 Description: 27TB Status: Enabled Entitlement ID: Start Date: End Date: Is Eval: No In Use: Yes 14897 14889 OST limiter throughput below the set value. Add the option to the CLI to show if the SNMP Trap's email is on or off. The throttling speed limits that can be set using the DR Series system CLI commands (replication --limit --speed) would not match the set replication bandwidth limits. Corrected some minor issues with the OST limits to correct this issue. Added additional option to alerts -show -email command. Email SNMP Trap's : Yes or No Added additional option to alerts --show -email command to show status of Trap's e-mail. 14845 14724 13537 system --upgrade fails with error message "Upgrade image not found". After replacing a hardware CRU or FRU, The GUI and CLI now place the the DR may come up in support mode with uploaded SW package into the a request to upgrade the hardware. same directory so upon HW replacement this same image can be utilized to upgrade the new component when necessary with no special user action required. Replication speed limits not throttling as expected. The throttling speed limits that can be set using the DR Series system CLI commands (replication --limit --speed) would not match the set replication bandwidth limits. Corrected some minor issues with the replication limits to correct this issue. DR4100 system enclosure hot add fails in Release 2.0. Attempting to perform a "hot add" of an external expansion shelf enclosure in a DR4000 or DR4100 system fails because this is not a supported method of operation in the 2.0 product release. To prevent this error/failure condition from occurring, observe the following best practice: The workaround is to observe the following best practice for connecting an external expansion shelf enclosure to a Release 2.0 DR4000 or DR4100 system: • Power off the DR4000 or DR4100 system (this is a requirement for 2.0 with Dell OpenManage 7.1). 13