Dell PowerVault NX300 Troubleshooting Guide - Page 5

Installation Issues Table 1. Installation Issues Issue Description Workaround / Solution After reinstalling the If the operating system NOTE: The operating system can operating system, the reinstall DVD cannot only be installed on LUN 0 of the RAID configuration find an operating system internal controller. To configure a on the system does partition of 80 GB or RAID configuration other than not match the larger on Virtual Disk 0, RAID 1 (Dell PowerVault NX300, original factory it defaults to the RAID 5 NX3000, and NX3100) or RAID 5 configuration. configuration. (PowerVault NX200), create a virtual disk with LUN ID 0 before reinstalling the operating system. To workaround this issue, perform the following steps: 1 If possible, backup all data on all virtual disks. 2 Reboot your system and enter the Dell PowerEdge RAID controller (PERC) BIOS. For more information, see the PERC documentation at support.dell.com/manuals. 3 Create a virtual disk with the desired RAID configuration, LUN ID 0, and a capacity of 80 GB or more. 4 Reboot the Dell PowerVault Network Attached Storage (NAS) using the operating system reinstallation media or DVD. Error: -5000. A required system Unexpected resource cannot be system error. located or is faulty. This issue occurs because either the operating system reinstallation media, optical drive, or the system is in an invalid state. Troubleshooting Guide 5