Dell S3048-ON EMC SmartFabric OS10 Switch Configuration Guide for VxRail 4.7 - Page 38

Note: For the dual switch without VLT topology, the VLAN portion of the command output is as follows: NUM Status Description 1 Active 1/1/11:1,1/1/12:1,1/1/13-1/1/16,1/1/21-1/1/52 1611 Active External_Mgmt 1612 Active vMotion 1613 Active vSAN 1614 Active VM_Network_A 1615 Active VM_Network_B 3939 Active Internal_Mgmt Q Ports A Eth1/1/1-1/1/8,1/1/10:1, A Po127 T Po127 A Eth1/1/9:1,1/1/17-1/1/20 T Eth1/1/17-1/1/20 T Po127 T Eth1/1/17-1/1/20 T Po127 T Eth1/1/17-1/1/20 T Po127 T Eth1/1/17-1/1/20 T Po127 T Eth1/1/17-1/1/20 T Po127 For the single switch topology, the VLAN portion is as follows: NUM Status Description 1 Inactive 1/1/12:1,1/1/13-1/1/16,1/1/25-1/1/56 1611 Active External_Mgmt 1/1/17-1/1/24 1612 Active vMotion 1613 Active vSAN 1614 Active VM_Network_A 1615 Active VM_Network_B 3939 Active Internal_Mgmt Q Ports A Eth1/1/1-1/1/8,1/1/11:1, A Eth1/1/9:1,1/1/10:1, T Eth1/1/17-1/1/24 T Eth1/1/17-1/1/24 T Eth1/1/17-1/1/24 T Eth1/1/17-1/1/24 T Eth1/1/17-1/1/24 8.1.4 show ipv6 mld snooping interface The show ipv6 mld snooping interface vlan 3939 command is used to verify MLD snooping and querier are enabled on VLAN 3939 (shown in bold in the output below). These settings are required for discovery of the VxRail nodes before creating the VxRail cluster. S5248F-Leaf1A# show ipv6 mld snooping interface vlan 3939 Vlan3939 is up, line protocol is up MLD version is 2 MLD snooping is enabled on interface MLD snooping query interval is 60 seconds MLD snooping querier timeout is 130 seconds MLD snooping last member query response interval is 1000 ms MLD snooping max response time is 10 seconds MLD snooping fast-leave is disabled on this interface MLD snooping querier is enabled on this interface Multicast snooping flood-restrict is enabled on this interface 38 Dell EMC SmartFabric OS10 Switch Configuration Guide for VxRail 4.7