Dell S5000 FTOS 9.0(1.3) Configuration Guide for the Switch - Page 655

Tracking Route Reachability To configure object tracking on the reachability of an IPv4 or IPv6 route, use the following commands. To remove object tracking, enter the no track object-id command. Step 1 2 3 4 Task Command Syntax Command Mode Configure object tracking on the reachability of an IPv4 or IPv6 route. (Optional) Configure the time delay used before communicating a change in the status of a tracked route. (Optional) Identify the tracked object with a text description. (Optional) Display the tracking configuration and the tracked object's status. track object-id {ip route ip-address/prefix-len | ipv6 route ipv6-address/prefix-len} reachability [vrf vrf-name] Valid object IDs are from 1 to 65535. Enter an IPv4 address in dotted decimal format; valid IPv4 prefix lengths are from / 0 to /32. Enter an IPv6 address in X:X:X:X::X format; valid IPv6 prefix lengths are from / 0 to /128. delay {[up seconds] [down seconds]} Valid delay times are from 0 to 180 seconds. Default: 0. description text The text string can be up to 80 characters. show track object-id CONFIGURATION OBJECT TRACKING OBJECT TRACKING EXEC Privilege Figure 33-5. Command Example: track ip route reachability FTOS(conf)#track 104 ip route 10.0.0.0/8 reachability FTOS(conf-track-104)#delay up 20 down 10 FTOS(conf-track-104)#end FTOS#show track 104 Track 104 IP route 10.0.0.0/8 reachability Reachability is Down (route not in route table) 2 changes, last change 00:02:49 Tracked by: FTOS#configure FTOS(conf)#track 4 ip route 3.1.1.0/24 reachability vrf vrf1 Object Tracking | 655