Dell S5000 FTOS 9.0(1.3) Configuration Guide for the Switch - Page 678

www.dell.com | support.dell.com To ensure connectivity in your OSPFv2 network, never configure the backbone area as a stub area. Use these commands in the following sequence, starting in EXEC Privilege mode to configure a stub area. Step 1 Command Syntax show ip ospf process-id [vrf vrf name] database database-summary Command Mode EXEC Privilege Usage Review all areas after they were configured to determine which areas are NOT receiving type 5 LSAs. vrf name: Show only the OSPF information tied to the VRF process. 2 configure EXEC Privilege Enter the CONFIGURATION mode. 3 router ospf process-id [vrf {vrf CONFIGURATION Enter the ROUTER OSPF mode. name}] Process ID is the ID assigned when configuring OSPFv2 globally (page 58). vrf name: Enter the VRF key word and instance name to tie the OSPF instance to the VRF. All network commands under this OSPF instance are subsequently tied to the VRF instance. 4 area area-id stub [no-summary] CONFIG-ROUTER-O SPF-id Configure the area as a stub area. Use the no-summary keywords to prevent transmission in to the area of summary ASBR LSAs. Area ID is the number or IP address assigned when creating the Area (page 60). Use the show ip ospf database process-id database-summary command syntax (Figure 413) in the EXEC Privilege mode To view which LSAs are transmitted. Figure 34-12. Command Example: show ip ospf process-id database database-summary FTOS#show ip ospf 34 database database-summary OSPF Router with ID (10.1.2.100) (Process ID 34) Area ID 2.2.2.2 3.3.3.3 FTOS# Router 1 1 Network S-Net 0 0 0 0 S-ASBR Type-7 0 0 0 0 Subtotal 1 1 To view information on areas, use the show ip ospf process-id command in the EXEC Privilege mode. 678 | Open Shortest Path First (OSPFv2)