Dell W-7010 AOS 6.4.x CLI Reference Guide - Page 1839

Parameter Free Channel Index Description The difference in the interference index between the new channel and current channel must exceed this value for the AP to move to a new channel. The higher this value, the lower the chance an AP will move to the new channel. Backoff Time Time, in seconds, an AP backs off after requesting a new channel or power level. Error Rate Threshold The percentage of errors in the channel that triggers a channel change. Error Rate Wait Time Channel Quality Aware Arm Channel Quality Threshold Channel Quality Wait Time Time, in seconds, that the error rate has to maintain or surpass the error rate threshold before it triggers a channel change. Shows if ARM changes are based on on channel quality and noise floor values. If this parameter is disabled, only noise-floor values will be used to change channels. Default: Disabled Displays the hannel quality percentage below which ARM initiates a channel change. If channel quality is below the specified channel quality threshold for this wait time period, ARM initiates a channel change. Minimum Scan Time Time, in seconds, that a channel must be scanned before it is considered for assignment. Load aware Scan Threshold The traffic throughput level an AP must reach before it stops scanning, in bytes/second. A value of 0 to disables this feature. Mode Aware Arm If enabled, ARM will turn APs into Air Monitors (AMs) if it detects higher coverage levels than necessary. This helps avoid higher levels of interference on the WLAN. Although this setting is disabled by default, you may want to enable this feature if your APs are deployed in close proximity (e.g. less than 60 feet apart). Scan Mode Client Match This parameter defines the scan mode for the AP. l all-reg-domain: The AP scans channels within all regulatory domains. This is the default setting. l reg-domain:Limit the AP scans to just the regulatory domain for that AP. The client match feature helps optimize network resources by balancing clients across channels, regardless of whether the AP or the controller is responding to the wireless clients' probe requests. If enabled, the controller compares whether or not an AP has more clients than its neighboring APs on other channels. If an AP's client load is at or over a predetermined threshold as compared to its immediate neighbors, or if a neighboring Dell AP on another channel does not have any clients, load balancing will be enabled on that AP. This feature is enabled by default 1839 | show rf arm-profile Dell Networking W-Series ArubaOS 6.4.x | User Guide