Dell W-Series 228 Instant 6.5.1.0-4.3.1.0 CLI Reference Guide - Page 2341

Description This command configures an SSID profile. Syntax Description Name of this instance of the profile. The name must be 1-63 characters. Range - Default "default" 902il-compatibility-mode (For clients using NTT DoCoMo 902iL - phones only) When enabled, the controller does not drop packets from the client if a small or old initialization vector value is received. (When TKIP or AES is used for encryption and TSPEC is enabled, the phone resets the value of the initialization vector after add/delete TSPEC.) NOTE: This parameter requires the PEFNG license. disabled a-basic-rates List of supported 802.11a rates, in Mbps, that are advertised in beacon frames and probe responses. 6, 9, 12, 18, 24, 36, 48, 54 Mbps 6, 12, 24 Mbps a-beacon-rate Sets the beacon rate for 802.11a (use for Distributed Antenna System (DAS) only). Using this parameter in normal operation may cause connectivity problems. default, 6, 9, 12, 18,24,36,48, 54 Mbps minimum valid rate a-tx-rates Set of 802.11a rates at which the AP is allowed to send data. The actual transmit rate depends on what the client is able to handle, based on information sent at the time of association and on the current error/loss rate of the client. 6, 9, 12, 18, 24, 36, 48, 54 Mbps 6, 9, 12, 18, 24, 36, 48, 54 Mbps advertise-ap-name If enabled, APs that are part of this VAP - - will broadcast the AP Name information in the beacons frames. advertise-location ageout auth-req-thresh If enabled, APs that are part of this VAP - will broadcast their GPS coordinates in the beacons and probe response frames as part of a vendor-specific Information Element. Time, in seconds, that a client is allowed to remain idle before being aged out. The SNR threshold below which incoming authentication requests are ignored. 0-100 dB disabled 1000 seconds 0 dB 2341| wlan ssid-profile Dell Networking W-Series ArubaOS 6.5.x | Reference Guide