Denon 3808CI Owners Manual - Page 52
Searching Categories, Accessing XM Radio Stations Directly, Checking the XM Signal Strength and, - receiver
UPC - 081757507646
View all Denon 3808CI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting uiop ENTER [ TU] (DEVICE2 mode) [f] ENTER uiop [SEARCH] [SAT TU] (AMP mode) [NUMBER] [ iPod] [8], [9], [6], [7], [1], [2] [ENTER] [uiop] [SEARCH] [CHANNEL +/-] [iPod] (AMP mode) (Main remote control unit) [2] [8] [REPEAT] [1/3] [9] [RANDOM] Checking the XM Signal Strength and Radio ID 1 Either turn or press [SAT TU] (AMP mode) to select "XM". 2 Press until "SIGNAL" appears on the display. The display will switch as shown below, depending on the reception conditions. Display GOOD MARGINAL WEAK NO GUI Status Signal strength is good Signal strength is marginal Signal strength is weak No signal 3 Adjust the position of the antenna until "SIGNAL: GOOD" is shown on the display. 4 Press until the station you want to check (example: "XM001") is displayed. 5 Press [f] and select channel 0 (XM000). The radio ID is shown on the display. Accessing XM Radio Stations Directly 1 Press [SEARCH]. 2 Press [NUMBER] then input the station's channel. Example: Accessing station "XM123": [1] → [2] → [3] b If no button is pressed within several seconds, the station automatically switches to the one whose number has been input. 3 Press ENTER to set that station. Reception switches to the selected station. • "LOADING" is displayed while stations or data are being received. • "UPDATING" is displayed while the encoding code is being updated. • "XM - - -" is displayed if the selected channel cannot be used. Radio ID The strength of both the XM satellite and terrestrial signals can be checked at GUI menu "Source Select" - "XM" - "Antenna Aiming" (vpage 40). Searching Categories 1 Press o p. (Sub remote control unit) About the button names in these explanations < > : Buttons on the main unit [ ] : Buttons on the remote control unit Button name only: Buttons on the main unit and remote control unit 49 Channel category 2 Use o p to select the category, then use ui to select the desired station.