Denon 5308CI Owners Manual - Page 12

GUI Menu Map Setup Playback Information Troubleshooting Symbols used to indicate buttons in this manual Button located on both the main unit and the remote control unit Button only on the main unit Button only on the remote control unit BUTTON [BUTTON] uio p [ AMP] [SAT TU] (AMP mode) [ TU] ( mode) [A ~ G] [ ] [MEMO] [ENTER] uio p [SEARCH] [CHANNEL + -] [NUMBER (0 ~ 9)] Basic Operation There is no SIRIUS-dedicated input terminal for AVP-A1HDCI / AVR-5308CI. When using an audio input source not used by AVP-A1HDCI / AVR-5308CI, assign SIRIUS to the source. 1 Make the necessary preparations. q Assign the SIRIUS input. : "Source Select" - "(input source)" - "Assign" - "SIRIUS" (vpage 7) w Change the TUNER(DEV2) setting on the main remote control unit to SIRIUS. : "Manual Setup" - "Option Setup" - "Remote (SIRIUS/XM)" (vpage 5) 2 Either turn or press [SAT TU] to select "SIRIUS". b When operating via the remote control unit, you cannot select SIRIUS even by pressing [SOURCE SELECT] to which SIRIUS has been assigned. 3 When using the main remote control unit to operate, press [TU] to select mode. 4 Use [ ] to select the channel. When the channel is tuned in, the name of the song and artist are displayed. • The channel switches continuously when [ ] is pressed and held. • The song title, artist name, composer name, category and reception level can be checked by pressing . • The time (default : 30 sec) for which the on-screen display are displayed can be set at GUI menu "Manual Setup" - "Option Setup" - "GUI" - "Tuner". • The sub remote control unit can also be used for SIRIUS (vpage 13). Checking the SIRIUS Signal Strength and Radio ID 1 Either turn or press [SAT TU] to select "SIRIUS". b When operating via the remote control unit, you cannot select SIRIUS even by pressing [SOURCE SELECT] to which SIRIUS has been assigned. 2 Press until "SIGNAL" appears on the display. The display will switch as shown below, depending on the reception conditions. Display EXCELLENT GOOD WEAK NO SIGNAL Status Signal strength is excellent Signal strength is good Signal strength is weak No signal 3 Adjust the position of the antenna until "SIGNAL: EXCELLENT" is shown on the display. 4 Press until the channel (example: "SR001") is displayed. 5 Press [ ] and select channel 0 (SR000). Channel No. and Sirius ID are alternately shown on the display. SR000 SiriusID Sirius ID b Write your own SIRIUS ID for storage use. Sirius ID : The strength of both the SIRIUS satellite and terrestrial signals can be checked at GUI menu "Source Select" - "SIRIUS" - "Antenna Aiming" (vpage 6). Presetting Radio Channels (Preset Memory) Your favorite broadcast channels can be preset so that you can tune them in easily. Up to 56 channels can be preset. 1 Tune in the broadcast channel you want to preset. 2 Press [MEMO]. 1