Denon AVR-1312 Getting Started Guide - Page 10

ENGLISH FDREAUNTÇSCAHIS FERSAPANÑÇOALIS POITARTLUIAGNUOÊS ESPAÑOL NEDERLANDS SVENSKA Speaker Config. (Cont.) Bass Setting Default settings are underlined. Distance Surround Back Set the presence, size and number of surround back speakers. • Large : Use a large speaker that can adequately play back low frequencies. • Small : Use a small speaker that has inadequate playback capacity for low frequencies. • None : Select when the surround back speakers are not connected. Even when the "Surround Back" setting is other than "None", sound may
not be emitted from the surround back speaker, depending on the playback source. In this case, make "Surround Parameter" - "SB CH OUT" (vm page 36 "Adjusting the sound field effects") setting other than "OFF". Subwoofer Set the presence of a subwoofer. • Yes : Use a subwoofer. • No : Select when a subwoofer is not connected. When "Front" is set to "Small", "Subwoofer" is automatically set to "Yes". 5 Press ENTER to enter the setting. Speaker Setup Speaker Config. Bass Setting Distance Channel Level Crossover Freq. Front Center Surround Surround Back Subwoofer 1 Use ui to select "Bass Setting", and then press ENTER. Speaker Setup Speaker Config. Bass Setting Distance Channel Level Crossover Freq. LPF for LFE SW Mode [ENTER] Enter [ ] Return 1 Bass Setting LPF for LFE SW Mode 120Hz LFE 2 Use o p to select the frequency. LPF for LFE Set LFE signal playback range. • 80Hz / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz / 200Hz / 250Hz 3 1 Use ui to select "SW Mode", and use o p to select a detailed setting. Use ui to select "Distance", and then press ENTER. 1 Bass Setting LPF for LFE SW Mode 120Hz LFE Speaker Setup Speaker Config. Bass Setting Distance Channel Level Crossover Freq. Step Front L/R Center Subwoofer Surround L/R SW Mode Select low range signals to be reproduced by subwoofer. • LFE : The low range signal of the channel set to "Small" speaker size is added to the LFE signal output from the subwoofer. • LFE+Main : The low range signal of all channels is added to the LFE signal output from the subwoofer. • "SW Mode" can be set when "Speaker Config." - "Subwoofer" (vpage 5) is set to "Yes". • Play music or a movie source and select the mode offering the strongest bass. • Select "LFE+Main" if you want the bass signals to always be produced from the subwoofer. NOTE If "Front" and "Center" for "Speaker Config." are set to "Large", and "SW Mode" is set to "LPF for LFE", no sound may be output from the subwoofers, depending on the input signal or selected surround mode. 4 Press ENTER to enter the setting. Speaker Setup Speaker Config. Bass Setting Distance Channel Level Crossover Freq. LPF for LFE SW Mode [ENTER] Enter [ ] Return 1 Distance Step Front L Front R Center Subwoofer 1ft 12.0ft 12.0ft 12.0ft 12.0ft 2 Use o p to change the step (minimum variable distance). 1ft : For changing in 1-foot steps. 0.1ft : For changing in 0.1-foot steps. 6