Denon AVR-3311 Owners Manual - Page 11

ENGLISH Set up speakers (Audyssey® Auto Setup) STEP 1 Preparation STEP 2 Speaker Detection STEP 3 Measurement 4 When the setup microphone is connected, the following screen is displayed. • In STEP 2, you will perform measurements at the main listening position. • This step automatically checks the speaker configuration and speaker size, and calculates the channel level, distance, and crossover frequency. It also corrects distortion in the listening area. 6 ENTER When measuring begins, a test tone is output from each speaker. • Measurement requires several minutes. 7 NOTE If "Caution" is displayed: Go to "Error messages" (vpage 10), check any related items, and perform the necessary procedures. If the problem is resolved, return and restart "Audyssey Auto Setup". When performing Audyssey Auto Setup over again Press ui to select "Retry", and then press ENTER. When measuring has stopped Press RETURN, to the "Cancel Auto Setup?" prompt is displayed. Press o to select "Yes", then press ENTER. • In STEP 3, you will perform measurements at multiple positions (two to eight positions) other than the main listening position. • You can achieve a more effective correction of distortion within the listening area by performing measurements at multiple positions. 9 ui ENTER The measurement of the second position starts. Measurements can be made in up to eight positions. Setting up the speakers again Repeat the operation from step 4 of STEP1 Preparation . Here, we explain setup using the example of 5.1-channel speaker playback. For settings other than 5.1-channel surround, select "Amp Assign" and perform step 3 and 4 of "Set up "Amp Assign"" (vpage 53). If unused channels are set with "Channel Select", measuring time can be shortened. For setting, perform steps 5 to 10 of "Set up "Channel Select"" (vpage 53). 5 ui ENTER NOTE If a connected speaker is not displayed, the speaker may not be connected correctly. Check the speaker connection. 8 ui 1 ENTER If you want to omit measurements from the next position onward, select "Next 1 Calculation". (Go to STEP4 Calculation ) 10 When measurement of position 8 is completed, a "Measurements finished." message is displayed. 8 Remote control operation buttons Move the cursor (Up/Down/Left/Right) Confirm the setting Return to previous menu