Denon AVR-3311 Owners Manual - Page 13
Parameter Check, Error messages - a b switch
View all Denon AVR-3311 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
ENGLISH Error messages Parameter Check An error message is displayed if Audyssey® Auto Setup could not be completed due to speaker placement, the measurement environment, etc. This function enables you to check the measurement results and If this happens, check the relevant items, be sure to take the necessary measures, then perform Audyssey Auto Setup over again. equalizer characteristics after Audyssey Auto Setup. NOTE Be sure to turn off the power before checking speaker connections. 1 ui ENTER p Examples Error details • The connected setup microphone is broken, or adevice other than the supplied setup microphone is connected. • Not all speakers could be detected. • The front L speaker was not properly detected. Measures • Connect the included setup microphone to the SETUP MIC jack of this unit. • Check the speaker connections. 2 ui ENTER p Measurement results for each speaker are displayed. • There is too much noise in the room for accurate measurements to be made. • Speaker or subwoofer sound is too low for accurate measurements to be made. • Either turn off any device generating noise or move it away. • Perform again when the surroundings are quieter. • Check the speaker installation and the direction in which the speakers are facing. • Adjust the subwoofer's volume. • The displayed speaker could not be detected. • Check the connections of the displayed speaker. Speaker Config. Check Check the speaker configuration. Distance Check Check the distance. Channel Level Check Check the channel level. Crossover Check Check the crossover frequency. EQ Check Check the equalizer. • If "EQ Check" is selected in step 2, press ui to select equalizing curve ("Audyssey" or "Audyssey Flat") to be checked. Use o p to switch the display between the different speakers. 3 RETURN The confirmation screen reappears. Repeat steps 2. • The displayed is connected with the polarities reversed. • Check the polarities of the displayed speaker. • For some speakers, this error message may be displayed even if the speaker is properly connected. If you are sure the connection is correct, press ui to select "Skip", then press ENTER. Retrieving Audyssey Auto Setup settings If you set "Restore" to "Yes", you can return to Audyssey Auto Setup measurement result (value calculated at the start by MultEQ® XT) even when you have changed each setting manually. 10 Remote control operation buttons Move the cursor (Up/Down/Left/Right) Confirm the setting Return to previous menu