Denon AVR1910 Owners Manual - English - Page 32

Getting Started Connections Settings Playback Multi-Zone Remote Control Information Troubleshooting Specifications ENGLISH Making the audio settings (Audio Setup) Default settings are underlined. Make settings for audio playback. Setting items Setting contents EXT.IN SW Level +15dB : This is the recommended level. Set the playback level of the +10dB / +5dB / 0dB : Select the level according to the player being used. analog subwoofer signals input from the external input terminals (EXT.IN). 2ch DIRECT/STEREO Setting : Select the method for setting the speakers used in the 2-channel Make speaker settings for 2- direct and stereo playback modes. channel mode playback. • Basic : The settings at "Speaker Setup" (vpage 25) are applied. • Custom : Make separate settings for 2-channel mode. Front : Set the front speaker size. • Large : Use of a large speaker that can adequately play back low frequencies. • Small : Use of a small speaker that has inadequate playback capacity for low frequencies. SW : Set the presence of a subwoofer. • Yes : Use a subwoofer. • No : Select when a subwoofer is not connected. SW Mode : Select low range signal to be reproduced by subwoofer. • LFE : Add the low frequency signal of the channel for which the speaker size is set to "Small" to the subwoofer signal and output it. • LFE+Main : Add the low frequency signal of all channels to the subwoofer signal and output it. Crossover : Outputs at below set frequency, each speaker's bass signal output from the subwoofer. • 40Hz / 60Hz / 80Hz / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz / 200Hz / 250Hz Distance FL / Distance FR : Select the speaker you want to set, and set the CH Level. Set the value that is closest to the measured distance. • 0.0ft ~ 60.0ft (12.0ft) / 0.00m ~ 18.00m (3.6m) CH Level FL/ CH Level FL FR : Select the speaker you want to set, and set the CH Level. Adjust the level of each channel. • -12.0dB ~ +12.0dB(0.0dB) Making detailed settings (Manual Setup) Setting items Setting contents Auto Surround Mode ON : Memorize settings. Most recently stored surround mode is Make setting for memorizing automatically selected. surround mode setting for OFF : Do not memorize settings. Surround mode does not change each input signal type. according to input signal. The auto surround mode function lets you store in the memory the surround mode last used for playing the four types of input signals listed below. q Analog and PCM 2-channel signals w Dolby Digital and DTS 2-channel signals e Dolby Digital and DTS multi-channel signals r Multi-channel signals other than Dolby Digital and DTS (PCM, etc.) NOTE When playing in the PURE DIRECT mode, the surround mode does not change even if the input signal is changed. EQ Customize Audyssey Byp. L/R / Audyssey Flat / Manual Set so that unused equalizer • Used settings are not displayed • Not Used when is used. NOTE • Set so that the "Audyssey Byp. L/R" and "Audyssey Flat" settings can be made when the Audyssey Auto Setup procedure is performed. • Equalizer settings for which "Not Used" is set with the Quick Select function cannot be stored and called out. 2 Remote control operation buttons Displaying the menu : Cancel the menu : Moves the cursor (Up/Down/Left/Right) : Decision the setting : Return to previous menu