Denon AVR1910 Owners Manual - English - Page 44
Checking the SIRIUS Signal Strength and Radio ID, Presetting Radio Channels Preset Memory, Listening - firmware
UPC - 083795000899
View all Denon AVR1910 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
ENGLISH Getting Started Connections Settings Playback Multi-Zone Remote Control Information Troubleshooting Specifications • The channel switches continuously when is pressed and held. • The song title, artist name, composer name, category and reception level can be checked by pressing on the main unit. • The time (default : 30 sec) for which the on- screen display are displayed can be set at menu "On-Screen Display" (vpage 31). Press uio p to return to the original screen. Front Checking the SIRIUS Signal Strength and Radio ID 1 Press to select "SIRIUS". Front 2 Press on the main unit until "SIGNAL" appears on the display. The display will switch as shown below, depending on the reception conditions. Display EXCELLENT GOOD WEAK NO SIGNAL Status Signal strength is excellent Signal strength is good Signal strength is weak No signal 3 Adjust the position of the antenna until "SIGNAL: EXCELLENT" is shown on the display. 4 Press on the main unit until the channel you want to check (example: "SR001") is displayed. 5 Press and select channel 0 (SR000). Front Channel No. and Sirius ID are alternately shown on the display. SR000 SiriusID ⇩ ************ Sirius ID b Write your own SIRIUS ID for storage use. Sirius ID : 41 The strength of both the SIRIUS and terrestrial signals can be checked at menu "Antenna Aiming" (vpage 37). Presetting Radio Channels (Preset Memory) Your favorite broadcast channels can be preset so that you can tune them in easily. Up to 56 channels can be preset. 1 Tune in the broadcast channel you want to preset. Searching Categories 1 Press o p. CAT : Pops Playing Components Channel category Front 2 Use o p to select the category, then use ui to select the desired channel. 2 Press . Front 3 Press to select the block (A to G) in which the channel is to be preset. 4 Press to select the preset number (1 to 8). 5 Press again to complete the setting. • "UPDATING" is displayed while the encoding code is being updated. • "SIRIUS UPDATING" is displayed when updating SIRIUS tuner firmware. • Refer to "Troubleshooting" - "SIRIUS Satellite Radio" regarding other messages (vpage 64). Parental Lock 1 Tune to the channel you want to lock. 2 Press for at least 3 seconds. "Code: [ ]" is displayed. Front To preset other channels, repeat steps 1 to 5. NOTE Preset channels are erased by overwriting them. Listening to Preset Channels 3 Enter the 4-digit lock code using uio p. When you enter the correct code, the corresponding channel is locked. 4 Press . 1 Press 2 Press to 8). to select the memory block (A to G). to select the desired preset channel (1 You can also operate via the main unit. In this case, perform the following operations. • P ress , then turn on the main unit to select the preset radio channel. • C hannels under Parental Lock cannot be tuned in by performing Tuning Up/Down or by category search. • C hannels stored in preset memory can be tuned in by the preset channel select operation, even if Parental Lock is applied. • W hen a channel to which Parental Lock is applied is being played, Parental Lock for that channel is cancelled by performing Step2. • S ee "Edit Lock Code" (vpage 37) for the method of changing Parental Lock Code. • Y ou can also set "Parental Lock" from the menu (vpage 37).