Denon AVR3310CI Owners Manual Addendum - English - Page 8

Getting Started Connections Settings Playback Information Unavailable Functions After Upgrading Specifications ENGLISH Make the Optimal Speaker Settings, and Correct the Room Acoustics (Audyssey™ Auto Setup) NOTE • Loud test sounds may be played during Audyssey MultEQ® automatic speaker setup. This is part of normal operation. If there is background noise in room, these test signals will increase in volume. • Do not stand between the speakers and setup microphone or allow obstacles in the path while the measurements are being made. This will cause inaccurate readings. • Make the room as quiet as possible. Background noise can disrupt the room measurements. Close windows, silence cell phones, televisions, radios, air conditioners, fluorescent lights, home appliances, light dimmers, or other devices as measurements may be affected by these sounds. Cell phones should be placed away from all audio electronics during the measurement process as Radio Frequency Interference (RFI) may cause measurement disruptions (even if the cell phone is not in use). • Operating MASTER VOLUME during the measurements will cancel the measurements. a Connect the Included Setup Microphone vpage 29 of GThe original versionH Operating Instructions s Audyssey Auto Setup Preparations around items indicate the default setting. STEP1 Preparation Perform the following settings if adjustments, etc., are required for the speaker environment you're using. If you do not need to perform the following settings, or have already completed them, select "Auto Setup Start" and then press ENTER. Proceed to " STEP2 ". Change the Amplifier Assignment (Amp Assign) The signal output from the SURR.BACK/AMP ASSIGN speaker terminal of the AVR-3310CI can be switched to match your speaker environment (vpage 8 "Amp Assign"). 1 Press ui to select "Amp Assign", then press ENTER. 2 Press o p to select Amp Assign Mode, then press RETURN. Normal : T he surround back channel audio signals are output. ZONE2 : The ZONE2 audio signals are output. ZONE3 : The ZONE3 audio signals are output. ZONE2/3-MONO : T he ZONE2 / ZONE3 monaural audio signals are output. Front A Bi-Amp : T he bi-amp audio signals are output. Set this for bi-amp playback of the front A speakers. Front B Bi-Amp : T he bi-amp audio signals are output. Set this for bi-amp playback of the front B speakers. Front Height : T he front height channel audio signals are output. Front Wide : T he front wide channel audio signals are output. indicates functions added by upgrading. • When you are using surround back speakers with ZONE2/ZONE3, set to "ZONE2" or "ZONE3". • You can set in the same way as described in "Amp Assign" on page 8. NOTE Since "Amp Assign" of AVR-3310CI is set to "ZONE2" by default, audio is not output from the surround back speakers. When using the surround back speakers with MAIN ZONE, change the "Amp Assign" setting to "Normal". Set the channel to be measured (Channel Select) vpage 30 of GThe original versionH Operating Instructions d Perform Audyssey Auto Setup vpage 30 of GThe original versionH Operating Instructions  Main remote control operation buttons :Displaying the menu Cancel the menu :Moves the cursor (Up/Down/Left/Right) :Confirm the setting :Return to previous menu