Denon DN-HC5000 Operating Instructions - Page 8

ENGLISH 3. Device Selection PARAMETERS knob • Press the ITCH/CD button for Deck A or Deck B (the side whose device you want to switch) to display the source selection screen. Display when ITCH is connected 4. Side Panel uy Display when CD is connected ITCH/CD for DECK1 ITCH/CD for DECK2 Note: • Press the BACK button to return to the normal mode. • Press the PARAMETERS knob to complete device selection. Display when ITCH is connected Display when CD is connected Note: • Turn the PARAMETERS knob to switch the display. Press the PARAMETERS knob or BACK button while the message below is displayed to return to the normal mode. q w er t q LINE OUT 1/2 terminals • This is unbalanced RCA output terminals. • Audio signals outputs. w DRIVE terminal • Connect the DN-D4000/D4500/BU4500 drive unit. For instructions on operating the DN-D4000/ D4500/BU4500, refer to the respective model's operating instructions. e USB B terminal • Connect to a computer. • Sends the control commands from the DN- HC5000. • Sends the USB audio signals from a PC. r POWER ON/OFF button • Press this button to turn power on and off. t AC IN terminal • Inlet the power cord's plug into DN-HC5000's AC inlet terminal. y FADER 1/2 terminals • Use this when your mixer has the Fader Start function. u X-CONTROL terminal • Use this when connected to a DENON DN-X900 or DN-X500 mixer that offers XControl. • With the DN-HC5000 it is possible to convert the input fader position into a control signal.  ENGLISH