Denon DN-X120 Owners Manual - Page 8

Getting Started Connections Playback Specifications ENGLISH Preparations CD player Connections Cables Used for Connections Refer to the connection diagram below. 1. Make certain AC power is off while making connections. 2. Quality cables make a big difference in fidelity and punch. Use high-quality, audio cables. 3. Do not use excessively long cables. Be sure plugs and jacks are securely fastened. Loose connections cause hum, noise, or intermittents that could damage your speakers. 4. Connect all stereo input sources. Then connect any effects into the stereo effect, if used. Connect your microphone(s) and monitor headphones. Make sure all faders are at "zero" and the unit is off. Take care to connect only one cable at a time. Pay attention to L and R position of jacks, on both the DN-X120 and outboard gear. 5. Connect the stereo outputs to the power amplifier(s) and/or tape deck(s) and/or MD recorder(s) and/or CD recorder(s). Plug the DNX120 into AC power outlet. Select the cables according to the equipment being connected. Audio cables For RCA PINJACK Unbalanced L L R R RCA pin pulag For BALANCED MASTER OUT Balanced Balanced (1/4" TS) Sleeve=GND Ring=Cold Tip=Hot For MIC Balanced (1/4" TRS) Sleeve=GND Ring=Cold Tip=Hot Balanced 1=GND 2=Hot NOTE Always switch on your audio input sources such as CD players first, then your mixer, and finally any amplifiers. When turning off, always reverse this operation by turning off amplifiers, then your mixer, and then input units. Sleeve=GND Ring=Cold Tip=Hot 3=Cold XLR3-11C For BALANCED MASTER OUT Balanced Balanced (1/4" TS) 2=Hot 1=GND 1/4" TRS jack Main balanced power amplifier AA-26: for AC 120V AA-27: for AC 230V AA-26 or AA-27 AC ADAPTOR To power outlet NOTE Use specified attached AC adaptor only. 3=Cold XLR3-12C Sleeve=GND Ring=Cold Tip=Hot CD player Turntable 2 Turntable 1 Balanced microphone 1/4" TRS mono jack 3.5 mm stereo mini cord 3.5 mm stereo mini cord Main unbalanced power amplifier b The attached AC adaptor is exclusively for use with this unit. Never connect to other devices.  1.DN-X120_ENG.indd 8 2007/12/28 18:07:36