Denon TU-604CI Owners Manual - English - Page 20

Getting Started Connections Setup Operations Remote Control Troubleshooting Specifications ENGLISH k DRC Value DAB Change DRC (Dynamic Range Control) value from broadcast station setting. The DRC (Dynamic Range Control) function lets you change the dynamic range of the received sound depending on the content of the broadcast so that the sound is easier to hear even when the volume is low. The dynamic range can be fine-adjusted in three steps. [Display] TUNER-6 DRC Value [Selectable items] OFF 1/2 1 l DAB Initialize DAB When the "DAB Initialize" procedure is performed, all the preset memory settings for the stations and DABs are reset. [Display] TUNER-6 DAB Initialize *DAB Initialize Start:Enter [Selectable items] Start : Enter : Starts initialization. • A blinking "Initialize" is displayed during initialization. • After the "Initialize" procedure is performed, the "Auto Tune" procedure is conducted automatically. • Once the "Auto Tune" procedure is completed, receivable channels are played. Lock Setting Set the channel radio reception limits. q Press ENTER. w Using or [uio p] and , input the password (4 digits number) and press ENTER. e Select channel by pressing [ui] or , and set the lock by pressing [o p]. [Selectable items] Unlock : Do not lock selected channel(s). Lock : Lock selected channel(s). b W hen a Parental Locked channel is tuned, "Enter Lock Code : [ ]" is displayed, then input the password. • The default password is "0000". • If the password is wrong, "Incorrect Code" is displayed. Input the correct password. • While listening to the channel being played, you can also set parental lock (vpage 29). Edit Lock Code Change the password. q Press ENTER. w Select "Current Code" and press ENTER. e Enter the Current Code using or [uio p] and . r Press ENTER to confirm. t Select "New Code" and Enter a New Code using steps w to r above. y Select "Repeat Code" and Re-enter the New Code using steps w to r above. u Select "Execute" and press [o] or . Network Setup Make network settings. F Menu tree F Main Setup Network Setup a Network Information s Network Setup • If you are using a broadband router (DHCP function), there is no need to make the settings at "Setting the IP Address" and "Setting the Proxy", since the DHCP function is set to "ON" in the TU-604CI's default settings. • If the TU-604CI is being used connected to a network without the DHCP function, the network settings must be made. In this case, some knowledge of networks is required. For details, consult a network administrator. • If you cannot connect to the Internet, recheck the connections and settings (vpage 11). • If you do not understand about Internet connection, contact your ISP (Internet Service Provider) or the store from which you purchased your computer. • DHCP (Dynamic Host Configuration Protocol) : These are systems by which the IP address and other network settings are automatically set for the TU-604CI, computer, broadband router and network devices. • DNS (Domain Name System) : This is a system for converting the domain names used when browsing Internet sites (for example, "www.denon.jp") into the IP addresses actually used for communications (for example, "202.221.192.106"). A0 Parental Lock For any channel, set the radio reception limits. [Display] TUNER-5 Parental Lock SIRIUS • If the old password is incorrectly input, "Current Lock Code Incorrect" is displayed, and proceed again from step q. • If the password input is 3 digits or less, "Enter 4 digits" is displayed, and input again with a 4 digit password. • If the new password is not correctly input, "New Lock Code do not Match" is displayed and the password does not change. a Network Information Display network information. [Items to be checked] DHCP= ON or OFF IP Address *Parental Lock Lock setting MAC Address Enter Lock Code [ ] *Lock setting SR001:•Unlock- 17