Dewalt DW7440RS Instruction Manual - Page 3

English Definitions: Safety Guidelines The definitions below describe the level of severity for each signal word. Please read the manual and pay attention to these symbols. DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury. WARNING: Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury. CAUTION: Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury. CAUTION: Used without the safety alert symbol indicates a potentially hazardous situation which, if not avoided, may result in property damage. IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS OR ANY DEWALT TOOL, CALL US TOLL FREE AT: 1-800-4-DEWALT (1-800-433-9258) DW7440RS Rolling Table Saw Stand with Folding Legs WARNING: For your own safety, read the table saw instruction manual before using any accessory. Failure to heed these warnings may result in personal injury and serious damage to the table saw and the accessory. When servicing this tool, use only identical replacement parts. This stand is designed for use with table saws only. The DW7440RS is approved for use with the DW744, DW744X and the DW745 table saws. If you experience a problem with your DEWALT purchase, please call 1-800-4-DEWALT (1-800-433-9258). Tools Required Phillips screwdriver Socket or wrench set Contents Stand Carriage head bolts (2) Mounting brackets (2) M8 lock nuts (4) Wheels (2) Rear axle Rubber bumpers (2) M4 screws (2) Washers (4) M4 lock nuts (2) Kickstand assembly M6 screws (4) Tube plugs (2) M4 hex wrench Saw mounting hardware: hex head bolts (4), washers (8), nuts (4), lock washers (4) General Safety Instructions for Table Saw Accessories WARNING: To reduce the risk of personal injury: • ALWAYS use eye protection. All users and bystanders must wear eye protection that conforms to ANSI Z87.1. • Ensure all stand fasteners are securely fastened and that all stand mechanisms are in proper working order before operating the table saw. • DO NOT exceed the weight this stand can hold. The DW7440RS table saw stand is designed to support 150 lbs. (68 kgs.) safely in a work environment. It is unsafe to climb, sit or stand on the stand. 2