Dewalt DWE46127 Instruction Manual - Page 9

Flange / Grinder Compatibility Chart Flange set Grinder Long (black) flange set: Locking flange 13 Backing flange 14 DWE43214, DWE43214N, DWE43214NVS, DWE43240INOX, DWE43231VS, DWE43244N, DWE43240VS, DWE46253, DWE46202, DWE43265N, DWE43840CN DWE43113, DWE43115, DWE43115N, DWE43066, DWE43066N, DWE43116, DWE43116N, DWE43114, DWE43114N, DWE43131, DWE43144, DWE43144N, DWE43140, DWE46103, DWE46153, DWE46155 DWE402G, DWE402K, DWE402, DWE402N DWE4222, DWE4222N, DWE4214 DCG414, DCG415, DCG416, DCG418 DWE4020, DWE4120, DWE4011 Depth of Cut Adjustment (Fig. A) 1. Loosen the depth of cut adjustment knob 5 . 2. Slide the depth of cut adjustor 4 to the desired position. NOTE: If the shroud is closed, press the front shroud button 7 to open the shroud. This will make it easier to move the depth of cut adjustor. 3. Tighten the depth of cut adjustment knob. Dust Extraction (Fig. A, G)  WARNING: Use only power tools and dust extractors recommended by DeWALT with this attachment. For more information about DeWALT power tools compatible with this attachment, please contact your local dealer, call 1-800-4-DeWALT (1-800-433-9258) or visit our website www.DeWALT.com.  WARNING: This attachment must be used with a dust extractor system. ALWAYS wear certified safety face or dust mask. NOTE: Ensure hose connection is secure. NOTE: The amount of dust retained by the dust extractor vacuum is dependent on its filter system. Refer to the dust extractor vacuum instruction manual for more information. All DeWALT dust collection shrouds are designed to work with the DeWALT Air lock™ universal DWV9000 connector. 1. Attach the DWV9000 connector 22 to your dust collector hose 23 . 2. Unlock the DWV9000 connector and slide onto dust port 1 . 3. Lock the DWV9000 connector to secure. Fig. G 23 English 22 1 Traditional Dust Extractor Vacuum Hoses Attach recommended dust extractor vacuum hose to dust port 1 . Removing and Attaching Guiding Wheels (Fig. H)  WARNING: The cutting shroud should only be used either (1) when all four wheels are attached and in good working condition or (2) when all four wheels are removed and the metal base is in good working condition. This cutting shroud comes with four removable guiding wheels 6 on the metal base 3 which can be detached if not needed. 1. Remove the clips 26 holding the wheels to the base. 2. Remove the guiding wheels. 3. Remove the pivot pin 27 . To attach the guiding wheels to the base, reinsert the pivot pin, slide the wheels on their axles and secure the clips in place. Make sure all four guiding wheels are securely attached before using the cutting shroud. Fig. H 6 27 26 3 6 OPERATION  WARNING: To reduce the risk of serious personal injury, turn unit off and disconnect it from power source before making any adjustments or removing/installing attachments or accessories. An accidental start-up can cause injury. 7