Dewalt DWE46266N Instruction Manual 1 - Page 11

Rotating The Gear Case (Fig. F) 1. Remove guard and flanges from tool. 2. Remove the four corner screws attaching the gear case to motor housing. 3. While keeping contact between gear case and motor housing, rotate the gear case to the desired position. Fig. F Fig. G 3 20 English 2 90˚ 90˚ 19 4. Re-install screws to attach the gear case to the motor housing. Tighten screws to 18 in./lbs. (2.03 Nm) torque. Overtightening could cause screws to strip. 5. Re-install guard and correct flanges for the appropriate accessories. Flanges and Wheels CAUTION: Turn unit off and unplug the tool before making any adjustments or removing or installing attachments or accessories. Mounting Non-Hubbed Wheels (Fig. A, G) WARNING: Failure to properly seat the flanges and/or wheel could result in serious injury (or damage to the tool or wheel). CAUTION: Included flanges must be used with depressed center Type 27/42 grinding wheels and Type 1/41 cutting wheels. See the Accessories Chart for more information. WARNING: A closed, two-sided cutting wheel guard is required when using abrasive cutting wheels or diamond coated cutting wheels. WARNING: Use of a damaged flange or guard or fail­ ure to use proper flange and guard can re­sult in injury due to wheel breakage and wheel contact. See the Accessories Chart for more information. 1. Place the tool on a table, guard up. 2. Install the unthreaded backing flange 2 on spindle 19 with the raised center (pilot) facing the wheel. 3. Place wheel 20 against the backing flange, centering the wheel on the raised center (pilot) of the backing flange. 4. While depressing the spindle lock button and with the hex depressions facing away from the wheel, thread the threaded locking flange 3 on spindle so that the lugs engage the two slots in the spindle. 5. While depressing the spindle lock button, tighten the threaded locking flange 3 using a Hex wrench. 6. To remove the wheel, depress the spindle lock button and loosen the threaded locking flange. Mounting Sanding Backing Pads (Fig. A, H) NOTE: Use of a guard with sanding discs that use backing pads, often called fiber resin discs, is not required. Since a guard is not required for these accessories, the guard may or may not fit correctly if used. WARNING: Failure to properly seat the clamp nut and/or pad could result in serious injury (or damage to the tool or wheel). WARNING: Proper guard must be reinstalled for grinding wheel, cutting wheel, sanding flap disc, wire brush or wire wheel applications after sanding applications are complete. 1. Place or appropriately thread backing pad 21 on the spindle. 2. Place the sanding disc 22 on the backing pad 21 . 3. While depressing spindle lock button 1 , thread the sanding clamp nut 23 on spindle, piloting the raised hub on the clamp nut into the center of sand­ ing disc and backing pad. 4. Tighten the clamp nut by hand. Then depress the spindle lock button while turning the sanding disc until the sanding disc and clamp nut are snug. 5. To remove the wheel, grasp and turn the backing pad and sanding pad while depressing the spindle lock button. Fig. H 23 22 21 9