Dewalt DWE7491RS Instruction Manual - Page 6
SAVE THESE INSTRUCTIONS FOR FUTURE USE, Specifications, Unpacking Fig. 1, FEATURES Fig. 2, 3 - power tools
View all Dewalt DWE7491RS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
English WARNING: Use of this tool can generate and/or disperse dust, which may cause serious and permanent respiratory or other injury. Always use NIOSH/OSHA approved respiratory protection appropriate for the dust exposure. Direct particles away from face and body. SAVE THESE INSTRUCTIONS FOR FUTURE USE Specifications Amperes 15 A Table Size 21-7/8" (556 mm) X 26-3/8" (669 mm) Miter Angle 30° L&R Bevel Angle 0° to 45°L Blade Size 10" (254 mm) Max. Cut Depth, 0° Bevel 3-1/8" (79 mm) Max. Cut Depth, 45° Bevel 2-1/4" (57 mm) RPM, no load 4800 Unpacking (Fig. 1) WARNING: To reduce the risk of injury, FIG. 1 DO NOT connect the machine to the power source until the table saw is completely assembled and you have read the entire instruction manual. Open the box and slide the saw out, as shown in Figure 1. Carefully unpack the table saw and all loose items from the carton. Examine all parts to make sure that parts have not been damaged during shipping. If any parts are missing or damaged, contact your dealer to replace them before attempting to assemble the tool. FEATURES (Fig. 2, 3) WARNING: Never modify the power tool or any part of it. Damage or personal injury could result. Examine Figures 2 and 3 to become familiar with the saw and its various parts. The following sections on assembly and adjustments will refer to these terms and you must know what and where the parts are. A. Table M. Splitter B. Blade N. Anti-kickback assembly C. Rip scale indicator O. Dust collection port D. Fine adjust knob P. Guard dust collection port E. Rail lock lever Q. Throat plate F. Blade height adjustment wheel R. Rip fence G. Bevel lock lever S. Rip fence latch H. ON/OFF switch T. Work support/narrrow rip fence (shown I. Mounting holes in stored position) J. Miter gauge U. Blade wrenches (stored position) K. Blade guard assembly V. Push stick (stored position) L. Riving knife/blade guard release lever W. Riving knife (non thru sawing) (FIG. 27) FIG. 2 A K Q L J C H FIG. 3 V T T R S E D GF P B M N U O S I INTENDED USE This table saw is designed for professional ripping, crosscutting, mitering, beveling and non thru-cutting applications, such as dadoing, with various materials. DO NOT use for cutting metal, cement board, or masonry. DO NOT use under wet conditions or in presence of flammable liquids or gases. DO NOT let children come into contact with the tool. Supervision is required when inexperienced operators use this tool. 4